Black Horse Model BH 124, Инструкция по эксплуатации

Страница: 8 / 62

PZL-140 WILGA Item code: BH124 Instruction Manual
8
PREPARATIONS
Use a covering iron with a covering sock
on high heat to tighten the covering if necessary.
Apply pressure over sheeted areas to thoroughly
bond the covering to the wood.
INSTALLING THE AILERONS AND FLAPS SERVOS
5.
Place the servo into the servo tray/ hatch into the
servo box on the bottom of the wing and drill 1.5mm
pilot holes through the tray and servo box for each of
the four mounting screws. Secure the servo tray in
place using the mounting screws provided.
4.
Using the thread as a guide and using masking
tape, tape the servo lead to the end of the thread:
carefully pull the thread out. When you have pulled
the servo lead out, remove the masking tape and the
servo lead from the thread.
3.
Place the servo into the servo tray. Center
the servo within the tray and drill 1.5mm pilot holes
through the block of wood for each of the four moun-
ting screws provided with the servo.
1.
Install the rubber grommets and brass eyelets
onto the aileron servos.
2.
Using a modeling knife, remove the covering
from over the pre-cut servo arm exit hole on the ail-
eron servo tray / hatch. This hole will allow the servo
arm to pass through when installing the aileron pus-
hrods.
6.
Repeat step # 2 - # 5 to install the second aileron
servo in the opposite wing half.
For Flap servo
For Aileron servo.
BOTTOM VIEW
FLAP
AILERON
L
R