English
4
The state of charge indicator is an indication of approximate
levels of charge remaining in the battery pack according to
the following indicators:
The LED battery indicator displays the remaining charge
and warns you when the battery is low. The final LED will
flash continuously when there is only 1 minute of runtime
remaining. All LEDs will flash when the unit is discharged.
nOTE:
The state of charge indicator is only an indication
of the charge left on the battery. It does not indicate tool
functionality and is subject to variation based on product
components, temperature and end-user application.
Fig. D
2
12
Extendable Crevice Tool
1. To extend the crevice tool
4
, pull it out from the
vacuum nozzle
3
until it clicks in place.
2. To collapse the crevice tool
4
, push it into the vacuum
nozzle
3
until it clicks in place.
Dry pick up
For everyday spills of dry material.
-
Do not fill the dust bowl
5
beyond the end of the
filter.
Optimizing the suction force
In order to keep the suction force optimized, the filters must
be cleared regularly during use.
Emptying and cleaning the product.
Removing the dust bowl and filter (Fig. E, F)
WARNING:
The filter is reusable and
should be cleaned regularly.
1. Hold the dust bowl over a trash can before pressing the
dust bowl release button
6
to release the dust bowl
access door
11
as shown in figure E.
2. While holding the dust bowl over a trash can, lightly
shake it to empty the dust bowl
5
.
3. Lift the prefilter
12
out of the dust bowl
5
as shown
in figure F.
4. Lift the filter
13
out of the dust bowl
5
.
5. While holding the dust bowl over a trash can, empty the
dust bowl
5
.
6. Install the filter
13
into the dust bowl
5
, then install
the prefilter
12
into the dust bowl
5
.
7. Close the dust bowl access door
11
until it clicks firmly
into place.
WARNING:
Never use the appliance
without the filters. Optimum dust collection will only
be achieved with a clean filter.
Fig. E
6
11
Fig. F
7
5
13
Cleaning the dust bowl and filter
The prefilter
12
and filter
13
can be washed in warm soapy
water. The dust bowl
5
can be wiped clean with a dry cloth.
1. Make sure the filter
13
, prefilter
12
and the
dust bowl
5
are dry before installing.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your BLACK+DECKER dealer.
Visit
www.blackanddecker.com
to locate dealers.
• Remove the old filters as described in
Cleaning
the Filters
.
• Fit the new filters as described in
Cleaning the Filters
.
(cat. no: HHVKF10)
These fit all units. When these filters reach the end of their
lifespan they must be disposed of at a local recycling center.
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never
let any liquid get inside the vac; never immerse any part of
the vac into a liquid.
WARNING:
Make sure the vacuum is
completely dry before using it.
