Black+Decker BFL420, Инструкция по эксплуатации

Страница: 21 / 24

21
ENGLISH
Adjust the Angle in Spotlight Mode
1. When adjusting the angle, press the angle adjustment
lock off switch 2 to release the lock, and adjust the
spotlight lighting part 3 to the desired angle.
2. After use, return the spotlight to its original position and
press the angle adjustment lock-off switch until it clicks.
CAUTION! Be careful not to get your fingers caught
when adjusting the angle.
Use In The Lantern Mode / Hazard Light
Mode
1. When using in the lantern mode and hazard light mode,
hold the upper part (A) and lower part (B) of the main
body with your left and right hand and pull out the side
lighting part stored inside. When the side lighting unit
is pulled out firmly, the lantern mode is automatically
automatically activated, and the side light will turn on
in bright mode.
2. The lighting mode can be switched each time the switch
1 is pressed. The lighting mode changes in the following
order, so please set it to the desired lighting mode.
Lighting mode Lighting pattern
Lantern mode (bright) Side lighting section (2
sides) lights up brightly
Lantern mode
(moderate) Side lighting section
(2 sides) lights up
moderately
Hazard light mode Side lighting section (1
side) flashes in red
Spotlight mode The spotlight lighting
part
3 lights up
3. When turning off the light, please follow the same
procedure as when lighting. Automatically when the
side lighting unit is firmly housed inside the main unit
it will turn off.
ATTENTION!
• Do not look into the light directly or keep it out of sight
for a long time, as it may damage your eyes.
• The LED light of the light source can not be replaced.
• Be careful not to get your fingers caught when pulling
out and storing the side light parts.
USE HANGING HOOK AND MAGNET
Use the Hanging Hook
• This product can be used by hanging it with a hook. In
that case, please pull up and use the hanging hook 6
stored in the bottom of the main body.
• After use, store the hanging hook in the bottom of the
main body.
Note:
Before suspending the product, make sure that
the surface from which it will be suspended can bear
Fig. E
3
2
Fig. F
3
1
A
B
Side
lighting
section
Lantern mode (bright Lantern mode (moderate)
Spotlight mode Hazard light mode
Fig. G