Black+Decker BCFK35W, Инструкция по эксплуатации

Страница: 6 / 16

Page 6
INSTALLATION GUIDE
1. Unpack your freezer by removing all packaging materials like carton, base, foams,
adhesive tape, etc.
2. Remove all accessories, internal packaging material used to hold shelves, ice tray,
etc. in place.
3. Clean the remains of all adhesive tap used and remove all printed material
supplied.
4. Install the freezer in a convenient location away from extreme heat and cold.
Allow sufficient clearance between the freezer and side wall so the door(s) will
open without obstruction. Freezer is not designed for recessed installation.
5. The floor on which the freezer should be placed must be flat, hard, solid, and even.
The freezer should not be placed on any soft material such as foam, plastic, etc.
6. The following are recommended minimum clearances around the freezer for
proper air circulation:
Sides: 3/4” (19mm)
Back: 2” (50mm)
Proper air circulation will help your freezer work at maximum efficiency.
NOTE: The appliance must be correctly connected to the power supply.
WARNING
It is important to keep the power cord away from the compressor at the
back of the freezer as during operation, the compressor can reach a high
temperature and could cause serious damage to the power cord.
CAUTION
Care should be taken during the handling moving and use of the freezer to
avoid damaging the refrigerant tubing or increasing the risk of a leak.
SET UP & USE