EJ212 Electric Jack 1 Ton Assembly & Operating Instructions
8
OPERATION
Do not move the car while the electric jack is supporting the car. Keep your body away from the car or truck while the car jack is
lifting the car. Do not put your body under the car.
Do not park the car on a slope. Do not overload the electric jack.
Use the Electric Jack only on vehicles whose frames have seams capable of aligning with the slotted saddle on the jack.
Park the car on smooth and solid ground and confirm that the emergency brake is set. Do not park on a slope.
Start the engine and insert the plug of the electric jack into the car lighter jack or power source.
Place the electric jack on smooth and solid ground. The saddle of the electric jack should be placed under the car, allowing for a secure metal
surface to lift.
Block the tires opposite the tire being lifted.
Do not allow anyone in the vehicle while using the Scissor Jack. Always keep hands, fingers, and feet away from the moving parts of the
Scissor Jack when applying or releasing a load.
Press UP on the remote controller until the car is raised to the appropriate height.
Press DOWN on the remote controller to lower the car. Remove the power cord from the cigarette lighter or power source when finished.
Important: Use the Electric Jack only on vehicles whose frames have seams capable of aligning with the slotted saddle on the jack.
This Scissor Jack is designed to lift one wheel at a time for the purpose of emergency tire replacement. Once lifted, make sure to support the
load immediately with appropriate vehicle support stands (not included).
MAINTENANCE
Some chemicals can damage the product. Do not use harsh chemicals such as gasoline, carbon tetrachloride, paint
thinner, etc.
A qualified repair technician must perform any tool service or repair.
Service or maintenance performed by unqualified
personnel could result in injury. Use only identical replacement parts. Use of unauthorized parts or failure to follow maintenance
instructions may create a risk of electric shock or injury.
To replace the Fuse: A melted wire strand within the Fuse indicates the Fuse has "blown" and must be replaced. To replace the (20 Amp) Fuse,
unscrew the cap on the DC Plug and remove the blown Fuse. Then, insert a new Fuse in the DC Plug and replace the cap.
Store in a cool, dry place.
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool
may become hazardous when used on another tool.
(EJ212201503)
