Black Box SmartPath LWN602WA, Руководство по установке

Страница: 4 / 20

724-746-5500 | blackbox.com
Page 4
724-746-5500 | blackbox.com
SmartPath Enterprise Wireless Access Point, Outdoor Installation Guide
• To protect the LWN602WA from lightning, do not place it at the highest point of a building or structure.
• To protect your network from lightning, place a 10-/100-/1000BASE-T shielded CAT6 PoE af compatible lightning protector
(outdoor: AL-CAT6JTW, indoor: HGLN-CAT6JT) inline between the LWN602WA and the rest of the network. Refer to the
installation instructions for the Ethernet protector in the Chapter 9 of this manual.
WARNINGS:
To install the LWN602WA, you must be a qualified installation professional, licensed or certified in accordance with local
regulations.
Use only attachments and accessories specified by Black Box.
During operation, the surfaces of the LWN602WA can become hot. Use caution when handling it.
Make sure that the LWN602WA is connected to a suitably installed ground conductor. Contact the appropriate electrical
inspection authority if you are uncertain that suitable grounding is available.
Do not locate the LWN602WA enclosure near overhead power lines or other electric light or power circuits, or where it can come
into contact with such circuits. During installation, exercise extreme care not to come into contact with these circuits, which can
cause serious injury or death. For proper installation and grounding of the product, refer to national and local electrical codes:
NFPA (National Fire Protection Association) 70, National Electrical Code Article 810 (U.S.); Canadian Electrical Code, Part I, CSA
22.1 and Section 54 (Canada); and if local or national electrical codes are not available, refer to IEC (International Electrotechnical
Commission) 364, Part 1 through 7 (other countries).
Do not connect or disconnect antennas or cables from the LWN602WA during periods of lightning activity.
3. Device, Power, and Environmental Specifications
Understanding the range of specifications for the LWN602WA is necessary for optimal deployment and device operation. The
following specifications describe the hardware components, Power over Ethernet (PoE) electrical requirements, and the
environmental ranges in which the device can operate.
3.1 Device and Enclosure Specifications
Mounting Options —
Horizontal or vertical pole mount; pole must be 1" to 3.5" (2.5 cm to 8.9 cm) in diameter, Wall or flat
surface mount
Connectors — (1) RJ-45 Ethernet connector: autosensing 10/100/1000 BASET Mbps; compliant with the IEEE 802.3at standard
for PoE
Size — Without antennas: 3"H x 7
7
⁄
8
"W x 9
5
⁄
8
"L (7.6 x 20 x 22.4 cm)
Weight — With antennas: 4.85 lb. (2.199 kg);
With antennas and brackets: 6.05 lb (2.744 kg)
Antennas — (4) N-type female connectors for external antennas
3.2 Power Specifications
PoE Nominal Input Voltage — 48 V, 30 watts
3.3 Environmental Specifications
Temperature Tolerance — Operating: -40 to +131° F (-40 to +55° C);
Storage: -40 to +176° F (-40 to +80° C)
Relative Humidity — Up to 100%
Wind Speed Tolerance — > 165 mph (266 kph)
Environmental Compliance — IP68