Introduction
2
The MTU9230/MTU9240 have been designed to be plug and go, conforming to appropriate
standards, physically very compact, and rack mountable in sets of 2 using a dual face plate,
or 18 units in a rack mount kit for large installations. FC units often enable substantial
savings to be made in cable costs by utilising the cheapest effective cable type without
incurring the costs of additional router or switch interfaces.
We are continually developing new models, so if the interface combination required
is not listed in this guide, please contact us.
1.2 Safety
Where electrical signal cabling is connected to the units, do not connect to cabling which
would be required by BS6701 to be equipped with over-voltage protection. Electrical signal
ports should only be connected to SELV ports on other equipment in accordance with
EN60950 clause 2.3.
1.3 Electromagnetic Compatibility
In order to ensure EMC compliance all electrical signal and data cables and connectors must
use a screened connector shell with a screened cable. The cable screen must be terminated
to the screened connector shell and not connected to any pins of the connector. Failure to
use the correct connector may compromise EMC compliance.
1.4 EN55022 Declaration
FC units are a Class A product. In a domestic environment it may cause radio interference
in which case the user may be required to take adequate measures.
1.5 FCC Declaration
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at its own expense.
1.6 WEEE Directive
Both units are covered by Directive 2002/96/EC (OJ:L37/24/2003) on waste electrical and
electronic equipment (The WEEE Directive). Units must therefore not be disposed of in
a standard landfill.
