9
STEP 4 -
Network Setup and Hardware Switching
NETWORK SETUP AND HW SWITCHING
1. Power on the Gigabit Switch and enable
Jumbo Frame (8k) and IGMP v2.
2. Connect all transmitters and receivers
to the Gigabit Switch using CATx cables.
3. Connect all transmitters with video sources,
and all receivers with Display/TV using HDMI
cables.
4. Connect an IR emitter cable to the
transmitter’s or receiver’s IR Emitter Jack,
and point the IR emitter to transmitter’s
or receiver’s connected device’s IR receiver
window that you want to control.
5. Connect an IR Receiver cable to the
transmitter’s or receiver’s IR Receiver Jack,
and point the IR receiver to the transmitter’s
or receiver’s connected device’s IR remote.
6. Connect an RS-232 cable to the transmitter
and receiver where a RS-232 controller
or Display/TV/device can take RS-232
command.
NOTE: If the transmitter’s or receiver’s RS-232
port and the device’s RS-232 port are different
genders, use a gender changer.
7. Plug-in a DC power adapter to all transmitters
and receivers. The units power on.
8. Power on all Video Sources and start playing
video.
9. Power on all Displays/TVs and select HDMI
input. All displays/TVs show video depending
on the video channel selected.
10. To assign different video channels (sources),
use an IR Receiver cable or the 99-channel
IR remote controller on the receiver side
to switch the source channel, or change
the receiver’s video channel by using
pushbuttons on the receiver.
11. Select the video channel by using pushbuttons
(CH+/CH-) on every transmitter/receiver
based on the link mapping, and set it up
by pressing the “Set/Reset” button.
The 7-segment LED display (Video Channel)
will stop blinking when the setting
is completed.
12. To use the 99-channel IR remote controller,
see
Step 5 -Remote Control
on the next page.
