Black Box ME760A-R2, Руководство пользователя

Страница: 22 / 48

21
CHAPTER 3: Standalone Installation
3.4 Setting the Internal Controls
After you install the cabling, you’ll need to configure the LDM-MR19.2 for your
application by setting its internal straps (jumpers) and switches as necessary. The
numbers listed under the “Strap Identity” column in Table 3-2 on the next two
pages correspond to the numbered strap locations in Figure 3-2 on page 27.
CAUTION!
Be sure the LDM-MR19.2 is unplugged before you open it.
To set internal jumpers and switches, follow the steps below.
1. Loosen the screw holding the top cover in place (located at the top
of the rear panel).
2. Remove the top cover.
3. Adjust the jumpers and switches for the configuration you want.
4. Replace the top cover and tighten the retaining screw.
3.5 AC Power Cord
Plug the LDM-MR19.2’s power cord into a grounded 3-wire AC outlet.
Your LDM-MR19.2 should now be ready for continuous operation.
(text continues on page 26)