13
CHAPTER 4: Installation
The V.35 Single Fiber Driver is easy to install. Once you’ve configured the DIP
switches (described in
Chapter 3
), simply connect the single fiber cable, hook
up the V.35 interface, and plug the power-supply adapter into the Driver. The
illustration below shows the interface connections on the back of the V.35
Single Fiber Driver.
Figure 4-1. The Driver’s rear panel.
4.1 Single-Fiber Connection
These short-range modems are designed to work in pairs.
You will need one at each
end of the single multimode fiber cable. Depending which data-rate setting
you select, your cable may be a maximum of 1.5 or 3 miles long. The fiber
cable connects to each V.35 Single Fiber Driver using either an ST or an
SMA connector. The illustration on the next page shows a closeup of both
connectors.
4. Installation
V.35 Interface
Power
Fiber
