User Manual
LOCAL
informs the user about the status of the local device. The following four statuses are
possible
«blinking red»
informs the user about malfunctioning of the modem’s hardware and
software. In this case, the modem is out of order and should be
submitted to the service center for being repaired.
«red»
informs the user about an urgent alarm. An abruption of the
connection, the correspondence of the signal-to-noise ratio, which
does not allow to transmit information and a great number of errored
blocks, can cause an urgent alarm. See the “Command menu”
chapter for detail.
«amber»
informs the user about non-urgent alarms. An abruption of connection
over the user’s interface can cause non-urgent alarms.
«green»
absence of alarms. Normal functioning of the device.
REMOTE informs the user about the status of the remote device. At the time being the remote
configuring of modems is not provided.
LINK
The LED is lit upon an incorrect connection to the LAN.
ACT
The LED is lit on upon the detection of packets in the segment of the current LAN.
10/100
The LED is lit upon the connection to the LAN at 100 Mbit/s.
The back panel of the modem has:
the grounding bolt of the modem (option);
•
•
•
•
•
•
The “AC12V” power connector. The connection of the modem to the 220 V power supply is
implemented using an external power supply unit;
the “Monitor” connector to control the modem and store statistics;
switches to set operation modes of the modem in “field” conditions;
“PC” and “HUB” connectors to connect the modem to the LAN using a straight Patch Cord (to
the PC or HUB, respectively);
the “DSL” connector to connect the modem to the leased physical line.
Page 8 of 30
