Black Box LWE100A, Быстрый старт

Страница: 4 / 24

724-746-5500 | blackbox.com
Page 4
Chapter 1: Introduction; Chapter 2: Preparing for Installation
Available Models
LWE100A-KIT
The kit is plug-and-play. Simply remove the units from the package and connect the Wireless Ethernet Extenders to your network.
Be sure to align them with each other using the LED indicators on the sides of the units to achieve the best possible link. You
must have line-of-sight for the units to line up. Each unit is configured as a bridge. The software is already configured.'
You must have the default IP addresses for the Wireless Ethernet Extender Kit:
BBox_Bridge1 (192.168.1.2), BBox_Bridge2 (192.168.1.24).
The default username and password for the Wireless Ethernet Extender Kit is:
Username: admin
Password: password
NOTE: If the units are factory defaulted, they will no longer retain the wireless bridge configuration and will need to be
reconfigured. Contact Black Box Technical Support at 724-746-5500 or info@blackbox.com for assistance.
LWE100A
See the rest of this quick start guide for information about installing and configuring the unit as an access point (AP), customer
premises equipment (CPE), wireless distribution system (WDS), or AP repeater.
1. Introduction
The Wireless P-T-P Ethernet Extender is a multimode last-mile broadband solution for customers using wireless ISPs (WISPs) and
system integrators. It complies with the IEEE 802.11n standard and features high-power output. The Wireless P-T-P Ethernet
Extender supports high bandwidth with long range for outdoor applications.
Use the Wireless P-T-P Ethernet Extender as an AP, CPE, WDS, or AP repeater. You can deploy the extender outdoors as an access
point to provide outdoor wireless internet service. Or, use the extender as an outdoor CPE—it receives wireless signals over the
last mile, helping wireless Internet service providers (WISPs) deliver internet service where wired broadband internet service, such
as cable and DSL, is not possible. The easy-to-install Wireless P-T-P Ethernet Extender covers 2.4-GHz bands, providing outstand-
ing throughput performance outdoors.
2. Preparing for Installation
Read this chapter before installing the extender. It describes safety precautions and needed product information.
2.1 Professional Installation Required
Use a professional installer who is well trained in RF installation and knowledgeable about local regulations.
2.2 Safety Precautions
For your safety and proper hardware installation, read and follow these safety precautions:
1. If you are installing the Wireless P-T-P Ethernet Extender for the first time, for your safety as well as others’, use a professional
installer who is trained on the safety hazards involved.
2. Keep safety as well as performance in mind when selecting your installation site, especially where there are electric power and
phone lines.