Black Box LGC5600A, Руководство пользователя

Страница: 10 / 20

10
1.877.877.2269 BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
CHAPTER 3: INSTALLATION
STEP 2: APPLY POWER
AC Power for LGC5600A
To power the module using the AC/DC adapter, connect the DC plug at the end of the wire on the AC/DC adapter to the DC connector
on the module. Then connect the AC/DC adapter to the AC outlet. Confirm that the module has powered up properly by checking
the Power LED located on the front of the module.
Installation of the equipment should be such that the air flow in the front, back, side and top vents of the chassis are not compromised
or restricted.
Secure the grounding wire to the ground screw. See the figure below for the location of the grounding screw.
REAR VIEW OF THE LGC5600A WITH AC POWER CONNECTOR
NEVER ATTEMPT TO OPEN THE CHASSIS OR
SERVICE THE POWER SUPPLY. OPENING THE
CHASSIS MAY CAUSE SERIOUS INJURY OR DEATH.
THERE ARE NO USER REPLACEABLE OR
SERVICEABLE PARTS IN THIS UNIT.
WARNING!!!
DC Power for LGC5700A
A power source should be available within 5 ft. (1.5-m) of the module. The over-current protection for connection with centralized
DC shall be provided in the building installation, and shall be a UL listed circuit breaker rated 20 Amps, and installed per the National
Electrical Code, ANSI/NFPA-70.
The LGC5700A requires 50 to 57 VDC @ 1.16 Amp max rated power (see specification table). Appropriate overloading protection
should be provided on the DC power source outlets used.
WARNING: Only a DC power source that complies with
safety extra low voltage (SELV) requirements can be
connected to the DC-input power supply.