Black Box LGB5028A, Руководство по установке

Страница: 23 / 44

724-746-5500 | blackbox.com 724-746-5500 | blackbox.com
Page 23 LGB5028A Installation and Getting Started Guide
Chapter 5: Installing the Switch
Table 5-1. Supported SFP transceivers.
Description
1000BASE-SX GE SFP fiber module, LC multimode 850 nm
1000BASE-SX GE SFP fiber module, LC multimode 1310 nm, 2 km
1000BASE-LX GE SFP fiber module, LC single-mode 10 km
1000BASE-LX GE SFP fiber module, LC single-mode 30 km
1000BASE-LX GE SFP fiber module, LC single-mode 50 km
1000BASE-LX GE SFP fiber module, Bidirectional LC single-mode 10 km, 1310 nm
1000BASE-LX GE SFP fiber module, Bidirectional LC single-mode 10 km, 1550 nm
1000BASE-LX GE SFP fiber module, Bidirectional LC single-mode 20 km, 1550 nm
1000BASE-LX GE SFP fiber module, Bidirectional LC single-mode 20 km, 1310 nm
100BASE-FX FE SFP fiber module, LC multimode
100BASE-FX FE SFP fiber module, LC single-mode, 20 km
To install an SFP transceiver, follow these steps:
STEP 1: Consider network and cabling requirements to select an appropriate SFP transceiver type.
STEP 2: Insert the transceiver with the optical connector facing outward and the slot connector facing down.
NOTE: SFP transceivers are keyed so they can only be installed in one orientation.
STEP 3: Slide the SFP transceiver into the slot until it clicks into place.
NOTE: SFP transceivers are not included with the switch. Contact Black Box Technical Support at 724-746-5500
or info@blackbox.com to order the SFPs.
5.7 Connecting to a Power Source
To switch the power on and off, plug or remove the power cord from AC power socket, to switch the power on and off.
Figure 5-4. Inserting the power cord into the AC power socket.
STEP 1: Insert the power cable plug directly into the AC socket located on the back of the switch.
STEP 2: Plug the other end of the cable into a grounded, 3-pin, AC power source.
STEP 3: Check the front-panel LEDs as the device is powered on to be sure the SYSTEM LED is lit. If not, check that the power
cable is correctly plugged in.
WARNING: For International use, you may need to change the AC line cord. You must use a line cord set that has been approved
for the socket type in your country.