26
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
1.877.877.2269
BLACKBOX.COM
CHAPTER 8: POWER AND COOLING PROBLEMS
8.1 INSTALLATION
If the power indicator does not turn on when the power cord is plugged in, you may have a problem with the power outlet, power cord,
or internal power supply. However, if the unit powers off after running for a while, check for loose power connections, power losses
or surges at the power outlet. If you still cannot isolate the problem, the internal power supply may be defective. Verify that all system
components have been properly installed. If one or more components appear to be malfunctioning (such as the power cord or network
cabling), test them in an alternate environment where you are sure that all the other components are functioning properly.
8.2 IN-BAND ACCESS
You can access the management agent in the switch anywhere within the attached network using Telnet, a web browser. However, you
must first configure the switch with a valid IP address, subnet mask, and default gateway. If you have trouble establishing a link to the
management agent, check to see if you have a valid network connection. Then verify that you entered the correct IP address. Also, make
sure the port through which you are connecting to the switch has not been disabled. If it has not been disabled, then check the network
cabling that runs between your remote location and the switch
NOTE
: The management agent accepts up to four simultaneous Telnet sessions. If the maximum number of sessions already exists, an
additional Telnet connection will not be able to log into the system.
