Passive CCTV Hub Installation Guide
Page 10
Port Switch Settings:
4.
For each camera port, determine whether video, power and/or control is to be
transmitted via the same Cat5 cable. If only video is to be transmitted, then the
Power/Control terminals and port switch may be disregarded.
5.
In order to transmit video on one (1) twisted pair, remote power on two (2)
twisted pairs and control on one (1) twisted pair, set the port switch to Pass-
Thru Mode (IC452A) using a small flathead screwdriver, as shown in fig 6.
Ensure that there is a CCTV Pass-Thru Balun (IC452A) at the camera.
Figure 6: Port Setting – Pass-Thru Mode (IC452A)
6.
In order to transmit video on one (1) twisted pair and remote power on three (3)
twisted pairs, set the port switch to Power-Thru Mode (IC560A/IC561A) using
a small flathead screwdriver (fig 7). Ensure that there is a CCTV Power-Thru
Balun (IC560A or IC561A) at the camera.
Figure 7: Port Setting – Power-Thru Mode (IC560A/IC561A)
