Black Box IC400A, Руководство пользователя

Страница: 14 / 20

724-746-5500 | blackbox.com
Page 14
724-746-5500 | blackbox.com
4-Port CAT5 USB 2.0 Extender
Table 4-1 (Continued). Problems/Causes/Solutions.
Problem Cause Solution
All LEDs on both the 1. The USB device 1. Disconnect the extender from the computer.
local unit and the remote is malfunctioning.
unit are on, but the USB 2. Connect the USB device directly to the USB port on the
device does not operate 2. The computer does not computer.
correctly or is detected as an recognize the USB device.
“Unknown Device” in the 3. If the device does not operate properly, consult the user
operating system. 3. The application software for documentation for the device.
the device is not operating.
4. Update your system BIOS, chipset, or USB host controller
4. The extender is drivers from your system/motherboard manufacturer’s
malfunctioning. drivers from your system/motherboard manufacturer’s
Web site.
5. If the device operates properly when directly connected
to a computer, connect another device (of a different
type) to the extender. Connect the extender to the
computer.
6. If the second device does not operate, the extender may
be malfunctioning. Contact Black Box Technical Support
at 724-746-5500 or info@blackbox.com for assistance.
7. If the second device does not operate properly, the first
device may not be compatible with the extender.
A USB device is attached A USB device must have the 1. Install the required USB device driver on the computer
to the remote unit USB appropriate driver installed on operating system before attaching the USB device to the
port, but the remote unit the computer operating system. remote unit. See your USB device manufacturer’s Web
device LED is off. site for details.
2. Consult your USB device documentation and power your
USB device with the additional, USB device manufacturer
supplied, power supply (if available).
Device LED is orange and Overcurrent condition has Power cycle the remote unit.
units are no longer occurred because USB device
functioning. draws more power than can
be supplied per USB
specification (500 mA).
LED Host and LINK LEDs Firmware mismatch between 1. Use a different local unit and remote unit that have the
on local/remote units the local unit and the remote unit. same firmware revision.
blink intermittently.
2. Upgrade the local unit/remote unit firmware. Contact
Black Box Technical Support at 724-746-5500 or
info@blackbox.com for assistance.