13
CHAPTER 3: Installation
3.3 Setting the Interface Converter for MIL 188/114 Mode
Jumpers W2 through W6 are used to configure the MIL 188 connector on
the interface converter for MIL 188/114 operation. Figure 3-3 shows an
isolated graphic of jumpers W2 through W6 set for DCE operation. Each
jumper must be configured for either DCE or DTE operation. This setting
should be opposite of the DCE/DTE status of the equipment you will attach
to the 188 side of the converter. Simply insert the jumper’s DIP shunts into
the proper positions. The factory-default configuration of the MIL 188C
interface is MIL 188C set to DTE.
NOTE
The DTE and DCE settings on jumper W6 are reversed from the rest of
the MIL 188/114 mode jumpers. Check closely that you have set this
jumper correctly.
Figure 3-3. Jumpers W2 Through W6.
W2
W3
W4
W5
W6
DCE DTE
DCE DTE
DCE DTE
DCE DTE
DTE DCE
MIL
188/1
14
