25
CAMPUS PAGER
5.6 Receiving a Message Code with the Tone Pager
When a Tone Pager is turned ON and receives a page, it sounds 12 beeps and
flashes the received message code on its display, unless you press the
ON/OFF button to silence the pager before it finishes beeping. The 12 beeps
and message code display repeat about 10 seconds later. Press ON/OFF to
silence the pager when it beeps again, or the pager beeps once about every 60
seconds to remind you that there is a new call.
Press ON/OFF to stop the pager from beeping every 60 seconds.
If the message code is transmitted to all pagers, each pager repeats the 12
beeps three times at about 30 second intervals. Press ON/OFF to silence the
pager.
5.7 Receiving a Message Code with the Vibrating/Tone Pager
When a Vibrating/Tone Pager is turned ON and receives a page, it vibrates
once and flashes the received message code on its display, unless you press
the ON/OFF button to silence the pager before it vibrates. The pager beeps
once every 60 seconds and allows you to view old messages from newest to
oldest by pushing the on/off button.
Each pager has its own pager code, which allows the system to send a
message to a single pager, or to all of your system’s pagers using the
TRANSMIT ALL feature. You can record each of the pager codes, and their
corresponding users on the card located under the base unit.
5.8 Reviewing Stored Message Codes
The pager can store eight message codes. Repeatedly press ON/OFF to view
the stored message codes on by one, from newest to oldest. A “-” indicates the
end of the stored message codes.
When the memory is full and a new message is received, the oldest message
code is deleted from memory.
If a newly received message code is identical to the last message received, it
is not stored.
All stored message codes are erased when you turn the pager OFF.
