16
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
CHAPTER 4: USB EXTENDER MOUNTING OPTIONS
4.2 USB EXTENDER DIRECT SURFACE MOUNTING (USING YOUR OWN HARDWARE)
The bottoms of the EMD100USB enclosures features four pre-drilled holes for optional surface mounting.
FIGURE 4-2. MOUNTING HOLE ON THE EMD100USB ENCLOSURE
1. Mark the center point of each of the four holes on your mounting surface either by directly measuring or using a print out of the
stencil below.
2. Hardware recommendation: M3.0 locking washers and M3.0 screws (4 of each per extender) noting screw length will depend
upon thickness of mounting surface.
3. Drill through each of the four hole markings on the mounting surface using a 4.7625mm (3/16”) drill bit.
4. Align the bottom enclosure holes to the newly drilled out holes on the mounting surface.
5. Place a locking washer on each of the four screws and using a screwdriver, fasten the extender into place.
NOTE: To ensure the stencil below prints to scale be sure to set the page scaling setting to “none.”
42.0mm (1.6535'')
4.8mm (3/16'')
(4 Places)
77.0mm (3.0315'')
Distance between the enclosure mounting holes:
42.0 mm x 77. 0 mm
