Connections
Browser-based configuration utility
Use this utility when configuring the Agility Zero U Transmitter to work with
Agility receivers which are linked via a network. You will need to use a computer
connected to the same network as the Agility Zero U Transmitter (you can also
connect them directly).
To access the browser-based configuration utility
Run a web browser on your computer and enter the standard IP address of the
Agility Zero U Transmitter:
169.254.1.33
Note: If the IP address of the Agility Zero U Transmitter has been changed and is not
known, providing it is appropriate to do so, perform a
manual factory reset
(see
below) to restore the default address.
The opening page of the Agility configuration utility should be displayed:
Full user details and setup instructions can be found in the Support section at:
www.blackbox.com
Main status indicators
• Off
No power.
• Green
Operating - Video, USB and network link all present.
• Orange
Operating - But video, USB and/or network link missing.
• Red
(momentarily) Unit is booting up, or (consistently) Unit has failed, try rebooting.
• Red/green flashing
Unit is in backup mode.
• Blue
Factory reset has been activated.
• Red/blue flashing
Unit is in upgrade mode.
• Fast green flash
Unit is in identify mode.
To perform a manual factory reset
A factory reset returns the Agility Zero U Transmitter to its default configuration.
1 Power on the Agility Zero U Transmitter module.
2 Use a narrow implement (e.g. a straightened-out paper clip) to press-and-
hold the recessed reset button on the front panel for roughly fifteen seconds,
until the status indicators turn
blue
(Note: alternating red/green indications will
occur during the fifteen second period while the button is still pressed)
.
3 Release the reset switch. The indicators will remain
blue
for a short while
(less than ten seconds) while the Agility Zero U Transmitter configures itself
and should then change to
green
if all connections are correct; or
orange
if
one or more of the video, USB and/or network links are missing.
NOTE: If you are performing a factory reset and intend to disconnect the
power immediately after the reset, you must wait at least 30 seconds after
you have released the reset button for it to complete the process.
ACR500-QS Rev 1.2
Order toll-free in the U.S. or for
FREE technical support 24/7: Call 877-877-BBOX
(outside U.S. call 724-746-5500)
www.blackbox.com • [email protected]
WWW
.BLACKBOX.COM
Status
indicators
(see below)
Black USB plug provides USB
signals (plus power if the
external power adapter is not
present)
Red
USB plug provides power
only when the external power
adapter is not present
DisplayPort,
DVI-D or VGA
connector input
Ethernet port (plus
indicators) - Either link
directly to an Agility receiver
or via a network switch
Optional external
power input
Reset button
(see below
right)
Cable tie
mounting slot
