Model AC504A-WP
4
1. Introduction
1.1 General
The AC504A-WP is used to send PC Video or analog HDTV
(component video) on UTP (Cat5/5e/6) cables. Power is also
transmitted on the same Cat5 cable between the sender unit and the
receiver.
The AC504A-WP can extend the video up to 500 feet. The unit can
support the following video signals
¾
PC’s VGA video (RGBHV) at any resolution
¾
Component video (Y Pb Pr, or RGB), at any resolution - an
adapter cable HD15-to-3RCA will be required
¾
NTSC, PAL, or SECAM Composite video and stereo audio -an
adapter cable HD15-to-3RCA (video and R/L Audio) will be
required
At the receiving (remote) end the Cat5 signal is converted back to
VGA for connection to monitors, projector or other display devices
using a compatible unit (Black Box Model AC602A).
The AC504A-WP includes a power supply that powers itself and the
AC602A Receiver (power-over-UTP) for a clean and easy setup
(Note that if the length of Cat5 cable is longer than 300 feet, the
receiver may require its own power supply)
.
Alternatively, the power supply can be connected to the AC602A
remote receiver, in which case, the sender is powered through the cat5
cable.
Figure 1 – Connection Block Diagram
