13
CHAPTER 3: Installation
One system cable connects each remote unit to each system port on the central
unit’s rear panel.
3.2.1 C
ONNECTING THE
2-P
ORT
CAT5 VGA V
IDEO
S
PLITTER
(C
ENTRAL
U
NIT
)
You need to use two System Cables.
To connect the System Cables
1. Connect one of the system cable’s RJ-45 male connectors to the System 1 port
on the central unit’s rear panel.
2. Connect the other system cable’s RJ-45 male connector to the System port on
the rear panel of Remote Unit # 1.
3. Connect the second system cable’s RJ-45 male connector to the System 2 port
on the central unit’s rear panel.
4. Connect the second system cable’s RJ-45 male other connector to the System
port on the rear panel of Remote Unit # 2.
3.2.2 C
ONNECTING THE
C
ENTRAL
U
NIT WITH
F
OUR
P
ORTS
You need to use four system cables.
To connect the System Cables:
1. Connect one of the system cable’s RJ-45 male connectors to the System 1 port
on the central unit’s rear panel.
2. Connect the other system cable’s RJ-45 male connector to the System port on
the rear panel of Remote Unit # 1.
3. Repeat this scenario with the other three system cables—connecting the
central unit’s System 2, System 3, and System 4 ports to the System ports of
Remote Units #2, #3, and #4, respectively.
3.3 Installing the Screen Cable
The Screen Cable has a DB15HD male connector attached at one end, and a
DB15HD female connector attached at the other end, as Figure 3-3 illustrates.
