Page 20
724-746-5500 | blackbox.com
HD View HDMI
3.5.1 Storing the Screen’s DDC
To store the screen’s DDC, connect a CAT5 cable between the DDC ports of
the Transmitter and Receiver. The position of the STORED/SCREEN selector switch
position is not relevant.
NOTE: There is no need to connect:
• A video CAT5 cable between the Transmitter and Receiver
• The Transmitter to a player
Press the Transmitter’s GET button for less than three seconds. The Transmitter
reads the screen’s DDC and stores it. The DDC port’s LED 1 (see Figure 2-2) blinks
twice. If unsuccessful, the LED blinks rapidly ten times.
Once stored, there is no need to keep the DDC CAT5 cable connected.
3.5.2 Reading the Stored DDC
To read the stored DDC, move the STORED/SCREEN selector to STORED.
3.5.3 Reading the DDC from the Screen
To read the DDC from the screen:
1. The DDC CAT5 cable must be connected between the Transmitter and Receiver.
2. Move the STORED/SCREEN selector to SCREEN.
3.5.4 Restoring the Default DDC Data
The Transmitter comes with a stored factory default DDC.
NOTE: Only use the default DDC if you can’t use the screen’s DDC data, i.e.
where the DDC CAT5 cable between the Transmitter and Receiver is not
connected and the screen’s DDC was not saved in the Transmitter’s
memory.
The player will choose one of the resolutions listed in the default DDC data.
NOTE: If the screen does not support the resolution chosen by the player, no
video will be displayed.
To restore the default data:
Press and hold down the GET button on the Transmitter for more than three
seconds. The DDC port’s LED 1 (see Figure 2-2) blinks twice. If unsuccessful, the
LED blinks rapidly ten times.
