Black & Decker PRO LINE BPDR5510, Инструкция по эксплуатации

Страница: 5 / 8

5
ENGLISH
Labels on tool
The label on your tool may include the following symbols:
Electrical safety
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Lock-on button
3. Forward/reverse slider
4. Chuck
5. Sleeve
6. Bit Shaft
7. Chuck key
8. Hole
9. Speed diala
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Keyed chuck (fig. B)
• Open the chuck by turning the sleeve (5)
counterclockwise.
• Insert the bit shaft (6) into the chuck.
• Insert the chuck key (7) into each hole (8) in the side of
the chuck and turn clockwise until tight.
Removing and refitting the chuck (fig. C)
• Open the chuck as far as possible.
• Remove the chuck retaining screw, located in the chuck,
by turning it clockwise using a screwdriver.
• Tighten an Allen key into the chuck and strike it with a
hammer as shown.
• Remove the Allen key.
• Remove the chuck by turning it counterclockwise.
• To refit the chuck, screw it onto the spindle and secure it
with the chuck retaining screw.
Use
Warning! Let the tool work at its own pace. Do not overload.
Warning! Before drilling into walls, floors or ceilings, check
for the location of wiring and pipes.
Selecting the direction of rotation (fig. D)
For drilling and for tightening screws, use forward
(clockwise) rotation. For loosening screws or removing a
jammed drill bit, use reverse (counterclockwise) rotation.
• To select forward rotation, push the forward/reverse
slider (3) to the left position.
• To select reverse rotation, push the forward/reverse
slider to the right. Viewed when holding the drill in the
operating position. After any reversing operations, return
slider (3) to forward position.
Warning! Never change the direction of rotation while the
motor is running.
Switching on and off
• To switch the tool on, press the variable speed switch
(1). The tool speed depends on how far you press the
switch.
• For continuous operation, press the lock-on button (2)
and release the variable speed switch. This option is
available only at full speed.
• To switch the tool off, release the variable speed switch.
To switch the tool off when in continuous operation,
press the variable speed switch once more and release
it.
• Based on the different applications, turn around the
speed dial (9) to control the maximum speed.
Hz ....... Hertz
W ....... Watts
min ..... minutes
..... Alternating
Current
..... Direct
Current
Read
Instructions
Manual
Use Eye
Protection
Use Ear
Protection
...... Class II
Construction
...... Earthing
Terminal
...... Safety
Alert Symbol
.../min.. Revolutions
or Recipro-
cation per
minute
V ........ Volts
A ........ Amperes n
0
....... No-Load
Speed