6
INSTALLING AND REMOvING ThE BATTERY
WARNING:
Make certain the vac is switched off before
removing or installing battery.
TO INSTALL BATTERY PACk: Insert battery pack into the
vac until an audible click is heard (Figure C). Make sure
battery pack is fully seated and fully latched into position.
TO REMOvE BATTERY PACk: Depress the battery release
button (6) as shown in Figure C and pull battery pack out of the vac.
OPERATION
FIGURE D
NOTE: ThIS PRODUCT IS FOR DRY PICk-UP ONLY.
• To switch the vac on, slide the on/off switch forward.
• To switch the vac off, slide the on/off switch back.
ASSEMBLY
FIGURE E
•
Remove the dust bowl by pressing the dust bowl release
button and pulling the bowl down and out.
• Remove the filter by pulling it out of the dust bowl.
• Install the filter into the dust bowl by aligning the filter
triangle with the dust bowl triangle and placing it firmly into
position as shown in figure F.
NOTE:
It is very important that the filter is correctly in
position before use.
• To install the dust bowl, place it back onto the front of the unit
and click firmly into position.
MOUNTING ACCESSORIES
• The brush tool (9) has a brush that can be used for
dusting and upholstery cleaning.
• The crevice tool (8) allows for vacuuming in narrow and
hard to-reach places.
• To attach an accessory, press the accessory into dust bowl.
• To remove an accessory, pull the accessory out of the dust bowl.
CLEANING ThE PRODUCT
WARNING:
Never use this cordless hand vacuum
without its filters.
NOTE:
The filter is re-usable, do not confuse them with disposable dust bags, and do not throw it
away when the product is emptied. We recommend that you replace the filter every 6-9 months.
IMPORTANT:
Maximum dust collection will only be obtained with clean filters and
an empty dust bowl. If dust begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
• Remove the filter and shake or lightly brush any loose dust off the filter.
•
Empty the dust from the bowl and wash if necessary.
• Wash the filter regularly using warm, soapy water as shown in
figure G. Ensure that it is completely dry before using again.
NOTE:
The cleaner the filter is, the better the product will perform.
• The dust bowl can also be washed in warm soapy
water as shown in figure G. Ensure that it is dry before
re-attaching.
•
Never immerse the product in water. A damp cloth and
soapy water should be used to clean the exterior of the
motor section. Always ensure the product is completely dry before re-use or storing.
RUN TIME
• When fully charged, the average effective usage times are between 10-15 minutes.
• It may take several chargings before these times can be achieved.
OThER INFORMATION
If the product does not work, check the following:
• The charger was correctly plugged in for recharge. (It feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly attached to the base.
• The charger is plugged into a working electrical outlet.
C
D
E
G
F
