Black & Decker PIUSB, Инструкция по эксплуатации

Страница: 12 / 72

OPERATING INSTRUCTIONS
Power source requirements
The power source must provide 12 Vdc and must
be able to supply the necessary current to operate
the load.
WARNING: The charger must be connected only to
batteries with a nominal output voltage of 12 Volts. The
appliance will not operate from a 6 Volt battery and will
sustain permanent damage if connected to a 24 Volt bat-
tery.
The Power/Fault LED Indicator lights green when the
charger is properly connected to a functioning DC power
source. The USB outlets are ready to use. (If the
Power/Fault LED Indicator lights red, refer to the
Troubleshooting Section of this Instruction Manual.)
To turn the unit off, disconnect it from the 12 volt DC
power source.
Always connect the charger to the 12 volt DC power
source before plugging any devices into the unit.
The USB outlets allow simultaneous operation of two
devices. Simply plug the equipment into the unit and
operate normally.
12