4. If the Inverter does not work, make sure the ignition/accessory outlet is powering the accessory outlet.
Some vehicles require the ignition switch to be turned on.
5. Plug the (110/120 volt AC) appliance into the Inverter’s three-prong AC outlet and operate normally.
Notes:
The Inverter will not operate appliances and equipment that generate heat, such as hair dryers,
electric blankets, microwave ovens and toasters.
Remember to disconnect the unit from any power source when it is not in use.
Operation of the USB Charging Port
1. Connect the unit to a vehicle’s accessory outlet or other 12 volt DC power source. Make sure there is
adequate space for proper ventilation of the inverter.
2. Rotate the unit slightly to make sure there is good contact.
3. The Power/Fault LED Indicator will light green, indicating a proper connection. If the Power/Fault LED
Indicator lights red, a Fault condition exists. Refer to the Troubleshooting Section of this Instruction
Manual.
4. If the Inverter does not work, make sure the ignition/accessory outlet is powering the accessory outlet.
Some vehicles require the ignition switch to be turned on.
5. Plug the USB-powered device into the inverter’s USB Charging Port and operate normally.
Notes:
This inverter’s USB Charging Port does not support data communication. It only provides
5 volts/300mA DC power to an external USB-powered device.
Remember to disconnect the unit from any power source when it is not in use.
Protective Features
The inverter monitors the following conditions:
Low Battery Voltage — This condition is not harmful to the inverter, but could damage the power source,
so the inverter will automatically shut down when input voltage drops below 10.0 ± 0.3 volts DC.
Input Voltage Too High — The inverter will automatically shut down when DC input voltage exceeds 15.5
± 0.5 volts, as this can harm the unit.
Thermal Shutdown Protection — The inverter will automatically shut down when the unit becomes
overheated.
Overload/Short Circuit Protection — The inverter will automatically shut down when a short circuit
occurs.
Notes:
The Power/Fault LED Indicator will light red to indicate a Fault condition before automatic shutdown
occurs.
If unit shuts down, disconnect it from the 12 volt DC power source, remove the load, wait a few
minutes, then plug it back in, rotating slightly to make sure there is good contact.
Operating Tips
The inverter should only be operated in locations that are:
DRY — Do not allow water or other liquids to come into contact with the inverter.
COOL — Surrounding air temperature should ideally be
10-20°C (50-68°F)
. Keep the inverter away from
direct sunlight, when possible.
WELL-VENTILATED — Keep the area surrounding the inverter clear to ensure free air circulation around
the unit. Do not place items on or over the inverter during operation. The unit will shut down if the
internal temperature gets too hot. The inverter will auto-reset after it cools down.
SAFE — Do not use the inverter near flammable materials or in any locations that may accumulate
flammable fumes or gases. This is an electrical appliance that can briefly spark when electrical
connections are made or broken.
CARE AND MAINTENANCE
Storage
1. Ideal storage temperature range is 0-40°C (32-104°F).
2. Store and use the inverter in a cool, dry place with adequate ventilation for all-around air circulation.
6
PI100AB english.qxp 12/18/07 10:47 AM Page 6
