Black & Decker NV3620, Руководство пользователя

Страница: 6 / 36

6
ENGLISH (Original instructions)

Use your Black & Decker charger only
to charge the battery in the appliance/
tool with which it was supplied. Other
batteries could burst, causing personal
injury and damage.

Never attempt to charge nonrecharge-
able batteries.

If the supply cord is damaged, it must
be replaced by the manufacturer or
an authorised Black & Decker Service
Centre in order to avoid a hazard.

Do not expose the charger to water.

Do not open the charger.

Do not probe the charger.

The appliance/tool/battery must be
placed in a well ventilated area when
charging.
Warning!
personal injury or damage to property. In
case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed
that the mains voltage corresponds
to the voltage on the rating plate
and the information in the technical
data table.
Warning! Never attempt to replace
the charger unit with a regular mains
plug.
Electrical safety
Your charger has been designed
that the mains voltage corresponds
to the voltage on the rating plate.
Never attempt to replace the charg-
er unit with a regular mains plug.
Symbols on the charger
#
Installation
The product can be attached to a wall to provide a convenient
storage and charging point for the appliance.
suitable for the wall type and is appropriate to the weight of
the appliance.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Bowl release button
3. Dust bowl
4. Charger
5. Charging bracket
Fig. A
6. NV3620, NV4820 & NV6020
7. NV3620, NV4820 & NV6020 Only)
8. Wet/Dry foam insert (NW3620 & NW4820 Only)
9.
Fig. B
10. Squeegee (NW3620 & NW4820 Only)
11. Brush tool (NV3620, NV4820 & NV6020 Only)
12. Crevice tool (NV3620, NV4820 & NV6020 Only)
Only)
The symbol means this tool is
double insulated; therefore no
earth wire is required. Always
check that the power supply
corresponds to the voltage on the
rating plate.