Black & Decker ks900, Инструкция по эксплуатации

Страница: 7 / 12

7
Features
1. Lock-on button
2. On/off switch
3. Blade storage compartment cover
4. Shoe plate locking lever
5. Dust extraction outlet
6. Dust extraction adaptor
7. Shoe plate
8. Smart Select
TM
dial
9. Blade support roller
10. Tool-free blade clamp
Additional features (fig. A)
Additional features may be applicable depending upon the
product purchased. The additional features applicable to the
catalogue number purchased are shown in fig. A.
Assembly
Warning! Before attempting any of the following operations,
make sure that the tool is switched off and unplugged and that
the saw blade has stopped. Used saw blades may be hot.
Fitting the saw blade (fig. B)
Hold the saw blade (11) as shown, with the teeth facing
forward.
Push and hold the blade clamp (10) down.
Insert the shank of the saw blade into the blade holder (12)
as far as it will go.
Release the blade clamp (10).
Saw blade storage (fig. C)
Saw blades (11) can be stored in the storage compartment
located on the side of the tool.
Open the cover (3) of the saw blade storage compartment
by holding the tab on the top of the cover (3) and pulling it
outward.
The blades are retained in the compartment by a magnetic
strip. To remove a blade, press down on one end of the
blade to raise the other end, and remove.
Close the cover (3) of the saw blade storage compartment
and make sure that it is latched closed.
Warning! Close the compartment door securely before
operating the saw.
Connecting a vacuum cleaner to the tool (fig. D)
An adaptor is required to connect a vacuum cleaner or dust
extractor to the tool. The dust extraction adaptor (6) can be
purchased from your local Black & Decker retailer.
Push the adaptor (6) into the dust extraction outlet (5).
Connect the vacuum cleaner hose to the adaptor (6).
Use
Adjusting the shoe plate for bevel cuts (fig. E and F)
Warning! Never use the tool when the shoe plate is loose or
removed.
The shoe plate (7) can be set to a left or right bevel angle of
up to 45°.
Pull the shoe plate locking lever (4) outwards to unlock the
shoe plate (7) from the 0 deg position (fig. E).
Pull the shoe plate (7) forward and set the required bevel
15°, 30° and 45° indicated in the bevel angle window.
Push the shoe plate locking lever (4) back towards the saw
to lock the shoe plate (7).
To reset the shoe plate (7) for straight cuts:
Pull the shoe plate locking lever (4) outwards to unlock the
shoe plate (7).
Set the shoe plate (7) to an angle of 0° and push the shoe
plate backwards.
Push the shoe plate locking lever (4) back towards the saw
to lock the shoe plate (7).
We recommend the use of a residual current device with
a residual current rating of 30mA or less.