Black & Decker GLC2000, Руководство пользователя

Страница: 11 / 124

11
E N G L I S H
ELECTRICAL SAFETY
Your charger has been designed for a specific
mains voltage. Always check that the mains voltage
corresponds to the voltage on the rating plate.
Your charger is double insulated in
accordance with EN 60335; therefore no
earth wire is required.
Never attempt to replace the charger unit
with a regular mains plug.
CARTON CONTENTS
The carton contains:
1 Cordless grass trimmer
1 Lead-acid battery
1 Charger
1 Guard with mounting screws
1 Wall mount
2 Mounting screws
2 Wall plugs
1 Instruction manual
◆
Carefully unpack all parts.
OVERVIEW (fig. A)
1. On/off switch
2. Lock-off button
3. Battery
4. Battery release buttons
5. Secondary handle
6. Handle knob
7. Collar
8. Motor housing
9. Guard
10. Line trimming blade
11. Edge guide
12. Spool
13. Cutting line
14. Charger
15. Wall mount
ASSEMBLY
Before assembly, remove the battery from
the tool.
Fitting the guard (fig. B)
◆
Remove the battery from the tool.
◆
Place the guard (9) onto the tool as shown,
aligning the holes (16) in the guard with the
lugs (17) on the tool.
◆
Press the guard until it snaps into place (A).
◆
Push the guard forward (B).
◆
Securely tighten the screws (18).
Never use the tool unless the guard is
properly fitted.
Fitting and removing the battery (fig. C)
◆
To fit the battery (3) to the tool, line it up with
the tool as shown, set it onto the tool and slide
it down until it snaps into place.
◆
To remove the battery from the tool, keep the
battery release buttons (4) depressed and slide
the battery up.
Mounting the wall mount to the wall (fig. D)
The wall mount (15) is used to provide a convenient
storage and charging point for the tool.
◆
Find a suitable indoor location for the wall
mount. If you also want to charge the battery
on the wall mount, this location must be dry
and well ventilated.
◆
Position the wall mount as shown and mark the
location of the two mounting holes (19) on the
wall. Make sure that there is sufficient space to
hang the tool on the wall mount.
◆
Drill a hole (ø 6 mm, approx. 35 mm deep) at
each of the marked locations.
◆
Insert the plugs (20) provided into the holes.
◆
Mount the wall mount to the wall using the
screws (21) provided.
◆
If you want to use the wall mount location for
charging the battery:
- Guide the cable (22) through the slot (23)
as shown.
- Plug the charger (14) into a mains outlet.
◆
If you do not want to use the wall mount
location for charging the battery, remove the
charging insert (24) from the wall mount.
Fitting a new spool of cutting line (fig. E)
Replacement spools of cutting line are available
from your Black & Decker dealer (cat. no. A6481).