•
IMPORTANT WARNING
– When being used as an Edger, stones, pieces of metal and
other objects can be thrown out at high speed by the line. The tool and guard are
designed to reduce the danger. However, the following special precautions should be taken:
•
MAKE SURE
that other persons and pets are at least 100 feet (30m) away.
•
TO REDUCE THE RISK
of rebound (ricochet) injury, work going away from any nearby
solid object such as wall, steps, large stone, tree, etc. Use great care when working close
to solid objects and where necessary, do edging or trimming by hand.
•
AVOID ACCIDENTALLY STARTING
– Donʼt carry plugged-in tool with finger on trigger.
•
DO NOT FORCE THE TOOL
– at a rate faster than the rate at which it is able to cut
effectively.
•
USE THE RIGHT TOOL
– Do not use this tool for any job except that for which it is intended.
•
DONʼT OVERREACH
– Keep proper footing and balance at all times.
•
DONʼT ABUSE CORD
– Donʼt yank cord from power supply. Keep cord from heat, oil,
and sharp edges.
•
DAMAGE TO UNIT
– If you strike or become entangled with a foreign object, stop tool
immediately, unplug, check for damage and have any damage repaired before further
operation is attempted. Do not operate with a broken hub or spool.
•
DAMAGE TO CORD
– Keep power cord away from rotating line. If you damage the cord,
unplug it from the power supply before moving the tool or examining the damage. A
damaged cord must be replaced before further use.
•
DISCONNECT TOOL
– when not in use, when replacing line, or prior to cleaning.
•
AVOID DANGEROUS ENVIRONMENTAL CONDITIONS
– Do not use electric tools in
damp or wet locations. Follow all instructions in this Instruction Manual for proper
operation of your tool. Donʼt use the tool in the rain.
•
DO NOT OPERATE
portable electric tools in gaseous or explosive atmospheres. Motors
in these tools normally spark, and the sparks might ignite fumes.
•
STORE IDLE TOOLS INDOORS
– When not in use, tools should be stored indoors in a
dry, locked-up place out of reach of children.
•
GROUND FAULT CIRCUIT INTERRUPTER (GFCI)
protection should be provided on the
circuits or outlets to be used for the gardening appliance. Receptacles are available
having built in GFCI protection and may be used for this measure of protection.
•
SECURE EXTENSION CORD
using the cord retainer shown in
Figure 3
.
•
STAY ALERT
– Watch what you are doing. Use common sense. Do not operate tool
when you are tired.
•
MAINTAIN APPLIANCES WITH CARE
– Follow instructions in maintenance section.
Inspect extension cords periodically and replace if damaged. Keep handles dry, clean and
free from oil and grease.
•
CHECK DAMAGED PARTS
– Before further use of the appliance, a guard or other part
that is damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other condition that may affect its operation.
A guard or other part that is damaged should be properly repaired or replaced by an
authorized service center unless otherwise indicated elsewhere in this manual.
WARNING:
When servicing double insulated tools, USE ONLY IDENTICAL
REPLACEMENT PARTS. Replace or repair damaged cords.
WARNING:
To prevent electrical shock hazard, use only with an extension cord
suitable for outdoor use. Always connect extension cords to a fused line or one protected
by a circuit breaker.
ADDITIONAL WARNINGS FOR STRING TRIMMERS
1. Keep the air intake slots
(Figure 14)
clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top condition, store spare
pre-wound spools or bulk line in a plastic, sealable bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. DO NOT immerse tool in water or squirt it with a hose. DO NOT allow any liquid to get
inside it.
5. Do not store the tool on or adjacent to fertilizers or chemicals.
6. DO NOT clean with a pressure washer.
7. The line cutter on the edge of the guard can dull over time.
SAFETY WARNINGS AND INSTRUCTIONS: POLARIZED PLUGS
To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider
than the other) and will require the use of a polarized extension cord. The appliance plug
will fit into a polarized extension cord only one way. If the plug does not fit fully into the
extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized
extension cord. A polarized extension cord will require the use of a polarized wall outlet.
This plug will fit into the polarized wall outlet only one way. If the plug does not fit fully into
the wall outlet, reverse the plug. If the plug still does not fit, contact a qualified electrician to
install the proper wall outlet. Do not change the equipment plug, extension cord receptacle,
or extension cord plug in any way.
6
IIN
NS
ST
TR
RU
UC
CT
TIIO
ON
N M
MA
AN
NU
UA
AL
L
Catalog Number: GH1000
GH1100
GH2000
G
G
G
G
H
H
H
H
1
1
1
1
0
0
0
0
0
0
0
0
0
0
0
0
,,
,,
G
G
G
G
H
H
H
H
1
1
1
1
1
1
1
1
0
0
0
0
0
0
0
0
,,
,,
G
G
G
G
H
H
H
H
2
2
2
2
0
0
0
0
0
0
0
0
0
0
0
0
T
T
T
T
R
R
R
R
II
II
M
M
M
M
M
M
M
M
E
E
E
E
R
R
R
R
//
//
E
E
E
E
D
D
D
D
G
G
G
G
E
E
E
E
R
R
R
R
Cat No. GH1000, GH1100, GH2000 Form No. 90579142 August 2011
Copyright © 2011 Black & Decker Printed in China
WARNING: IMPORTANT SAFETY WARNINGS AND INSTRUCTIONS
TO REDUCE RISK OF INJURY:
• Before any use, be sure everyone using this tool reads and understands all safety
instructions and other information contained in this manual.
• Save these instructions and review frequently prior to use and in instructing others.
CAUTION:
Failure to comply with the recommendations outlined in the key information
section will void warranty.
WARNING:
When using electric gardening appliances, basic safety precautions should
always be followed to reduce risk of fire, electric shock, and personal injury, including the
following:
WARNING: Some dust created by this product contains chemicals known to the State
of California to cause cancer, birth defects or other reproductive harm. Some examples
of these chemicals are:
• compounds in fertilizers
• compounds in insecticides, herbicides and pesticides
• arsenic and chromium from chemically treated lumber
To reduce your exposure to these chemicals, wear approved safety equipment such as
dust masks that are specially designed to filter out microscopic particles.
WARNING:
This product contains chemicals, including lead, known to the State of
California to cause cancer, and birth defects or other reproductive harm. Wash hands
after handling.
CAUTION:
Wear appropriate personal hearing protection during use. Under some
conditions and duration of use, noise from this product may contribute to hearing loss.
READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE USING.
SAFETY GUIDELINES - DEFINITIONS
It is important for you to read and understand this manual.
The information it contains relates to protecting YOUR SAFETY and PREVENTING
PROBLEMS. The symbols below are used to help you recognize this information.
DANGER:
Indicates an imminently hazardous situation which, if not avoided, will result
in death or serious injury.
WARNING:
Indicates a potentially hazardous situation which, if not avoided, could result
in death or serious injury.
CAUTION:
Indicates a potentially haz ard ous situation which, if not avoided, may result
in minor or mod er ate injury.
CAUTION:
Used without the safety alert symbol indicates a potentially hazardous situation
which, if not avoided, may result in property damage.
GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL TOOLS
•
ALWAYS WEAR EYE PROTECTION
– Wear safety spectacles or goggles at all times
when this tool is plugged in.
•
GUARD
– Do not use this tool without guard attached.
•
DRESS PROPERLY
– Do not wear loose clothing or jewelry. They can be caught in
moving parts. Rubber gloves and substantial rubber soled footwear are recommended
when working outdoors. Donʼt operate the tool when barefoot or wearing open sandals.
Wear long pants to protect your legs. Wear protective hair covering to contain long hair.
•
NYLON LINE
– Keep face, hands and feet clear of rotating nylon line at all times.
•
THE ROTATING LINE PERFORMS A CUTTING FUNCTION
– Use care when trimming
around screens and desirable plantings.
•
KEEP ALL BY-STANDERS AWAY
– at a safe distance from work area, especially children.
KEY INFORMATION YOU SHOULD KNOW:
• The guard must be installed before trimming or edging - if not, the motor
will overheat.
• When replacing the line, use only .080 inch diameter ROUND line - other-
wise the unit will not function properly.
• Do not bump the feed head against the ground - it will disrupt the feed
mechanism.
• Angle tool slightly (5° to 10°) when trimming.
• Always use the cord retainer and the extension cord lock feature.
• For trouble free feeding and best results, only use Black & Decker
replacement spools with dual 0.080 inch line. Black & Decker
replacement spool model number DF-080.
Date Code:
1
2
3
4
5
Thank you for choosing Black & Decker!
Go to www.BlackandDecker.com/NewOwner
to register your new product.
PLEASE READ BEFORE RETURNING THIS
PRODUCT FOR ANY REASON:
If you have a question or experience a problem with your Black & Decker purchase, go to
H
HTTTTP
P::////W
WW
WW
W..B
BLLA
AC
CK
KA
AN
ND
DD
DEEC
CK
KEER
R..C
CO
OM
M//IIN
NS
STTA
AN
NTTA
AN
NS
SW
WEER
RS
S
If you can’t find the answer or do not have access to the internet,
call 1-800-544-6986 from 8 a.m. to 5 p.m. EST Mon. -- Fri. to speak with an agent.
Please have the catalog number available when you call.
for instant answers 24 hours a day.
SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE.
