12
NOTE: In order to use the
Freewire function of your
MASTER REMOTE your
system must include a
MESSENGER HUB.
SYNCHRONIZING THE REMOTE
WITH THE MESSENGER HUB
A Quick Note Before You Set Up The
MESSENGER HUB:
WARNING: For indoor use only.
Each receiver has a specific address
made up of a HOUSE CODE (bottom
dial) and a UNIT CODE (upper dial)
which is used to communicate with the
MESSENGER HUB.
The function of the HOUSE CODE is to
prevent interference from another
FREEWIRE system. If at any time, you
experience interference with another
system please choose another setting for
your HOUSE CODE A - P. The letter
selected must be the same on all
RECEIVERS and the MESSENGER
HUB.
Step 1:
Plug MESSENGER HUB into any
operational AC outlet within your home.
Rotate antenna to the upright position.
Open the front door to expose control
panel.
Step 2:
Select a HOUSE CODE on the
MESSENGER HUB, any letter A - P.
(Note: The house code you select for the
MESSENGER HUB will dictate what
letter you will select for all of the UNITS
you plan to control with this
MESSENGER HUB.)
Step 3:
Select a UNIT CODE on the
MESSENGER HUB, any number 1 - 16.
The number and corresponding color you
pick will control the lamp outlet located
on the underside of this MESSENGER
HUB. (If you select the same number and
same house code for any additional
UNITS on this system they will operate in
conjunction with this hub.)
Step 4:
SYNCHRONIZE your MASTER
REMOTE with your MESSENGER HUB
so they understand how to communicate
with each other. (Note: Any additional
remote that is introduced to the system
must also be synchronized.)
NOTE: Your MASTER REMOTE is now
SYNCHRONIZED with your Freewire
system and can now operate your
Freewire units. If you ever remove the
remote’s batteries you may need to
initialize and SYNCHRONIZE your
remote again. See BATTERY
INSTALLATION section on page 8.
To SYNCHRONIZE, move the
MESSENGER HUB slide switch to
LEARN.
While facing the MESSENGER HUB,
press and hold the middle “ON” button
of the MASTER REMOTE for 5 seconds.
Be sure to see the green light flash on
the MESSENGER HUB. The flash will
indicate that the MASTER REMOTE is
now synchronized with the
MESSENGER HUB.
Now, move the slide switch on the
MESSENGER HUB to RUN.
(Note: Door cannot be closed while
MESSENGER HUB is in the LEARN
mode.)
Step 5:
Turn lamp on first, then plug into the
receptacle on the underside of the
MESSENGER HUB. Use only
incandescent bulbs up to 500W. Be sure
the Lamp has been turned on prior to
plugging into MESSENGER HUB.
Press the Local Lamp “ON/OFF” button
on the MESSENGER HUB to check that
the MESSENGER HUB is operating
correctly. You will hear a “click” when the
MESSENGER HUB turns this lamp on
and off.
You are now ready to operate the lamp
connected to this MESSENGER HUB
with the MASTER REMOTE.
FREEWIRE OPERATION
622715-00 Master Remote manual 2/4/04 9:17 AM Page 12
