Black & Decker FreeWire FWMR, Руководство пользователя

Страница: 6 / 13

11 10
Code Search by Brand
Lets you search for a code for a specific Brand within
the Code Library for a particular manufacturer.
1. Turn on the device (
TV
,
VCR
, etc.) to be controlled.
2. Press and quickly release the desired mode button
(
TV
,
VCR
, etc.).
3. Press and hold the
SETUP
button until the Mode
buttons blink green, then the button you pressed in
step 2 stays on, then release the
SETUP
button.
4. Press and release the numeric button ( 0-9 )
corresponding to desired Manufacturer (see table on
next page). The green indicator blinks off once.
Note, pressing “0” performs a full library search same
as normal Code Search Method on previous page.
5. Press the
CHANNEL UP
button ((or
POWER
or
PLAY
(
VCR
only)) repeatedly until the device to be
controlled changes channel. The green indicator
blinks off with each button press. If you accidentally
overshoot the code required, press the
CHANNEL
DOWN
button to backtrack through the library until
the device changes channel. Pressing
CHANNEL UP
changes direction to forward again.
6. Press and release
MUTE
to install the code.
Brand Search Method entry is now complete.
Note : When all codes under a Brand have been searched
the red indicator flashes rapidly for 3 seconds.
Code Entry, cont.
3.
2.
6.
5.
4.
Programming with Code Search
If your product does not respond after you have tried all
the codes for your brand, or if your brand is not listed,
try searching for your code by following these steps.
1. Turn on the device (
TV
,
VCR
, etc.) to be controlled.
2. Press and quickly release the desired mode button
(
TV
,
VCR
, etc.).
3. Press and hold the
SETUP
button until the Mode
buttons blink green, then the button you pressed in
step 2 stays on, then release the
SETUP
button.
4. Press the
CHANNEL UP
button repeatedly (up to 300
times) until the device to be controlled changes
channel. The green indicator blinks off with each
button press. If you accidentally overshoot the
code required, press the
CHANNEL DOWN
button
to backtrack through the library until the device
changes channel. Pressing
CHANNEL UP
changes
direction to forward again.
5. Press and release
MUTE
to install the code.
Most users will store
VCR
codes under the
VCR
button,
DVD codes under
DVD
, etc. If (for example) you want to
store a
VCR
code under
DVD
, first follow the procedure
for Direct Code Entry (page 10) and press
DVD
in step 2
of Direct Code Entry, then enter ANY VCR code in step 3
of Direct Code Entry. Then follow the steps above for
Code Search (or Brand Search, page 12).
Note : If the device does not have a
CHANNEL UP
button, use
PLAY
(
VCR
only) or
POWER
instead. Code
Search starts from the currently stored three digit
number under that mode.
3.
2.
5.
Code Entry, cont.
4.