12
Using Circle Cutter (Figure J)
1. Attach circle cutter as described in “Attaching Circle Cutter”.
2. Adjust depth of cut if necessary.
3. Layout circle to be cut and find center point.
4. Move pivot point knob to desired diameter dimension and tighten knob.
5. Start saw and cut a pilot hole in the center of the intended circle.
6. Insert pivot knob into pilot hole.
7. Hold saw and circle cutter firmly as shown in figure J.
8. Begin cut working in a clockwise direction, applying moderate steady pressure.
Vac Adaptor (Figure K)
Attach the vacuum adaptor as shown in figure K. Insert vac hose (not supplied) into
adaptor.
MAINTENANCE
Cleaning
CAUTION:
Blow dirt and dust out of all air vents with dry air frequently. Wear safety
glasses when performing this. Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened only with water and mild soap.
Do not use gasoline, turpentine, lacquer or paint thinner, dry cleaning fluids or similar
products. Never let any liquid get inside the tool; never immerse any part of the tool
into a liquid.
IMPORTANT:
To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement
parts.
TROUBLESHOOTING
Problem
Possible Cause
Possible Solution
• Unit will not start.
• Battery pack not installed properly.
• Check battery pack
installation.
• Battery pack not charged.
• Check battery pack
charging requirements.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
charger until red LED
appears.
• Charger not plugged in.
• Plug charger into a
working outlet. Refer to
“Important Charging Notes”
for more details.
• Check current at
receptacle by plugging
in a lamp or other
appliance.
• Check to see if
receptacle is connected
to a light switch which
turns power off when
you turn out the lights.
• Surrounding air temperature
• Move charger and battery
to a surrounding air
temperature of above 40
degrees F (4,5°C) or below
105 degrees F (+40,5°C).
For assistance with your product, visit our website
www.blackanddecker.com
for the location of
the service center nearest you or call the BLACK & DECKER help line at
1-800-544 6986.
90521272 FS18SS Spiral Saw 8/15/07 10:16 AM Page 12
