Black & Decker Dustbuster V2410G, Руководство пользователя

Страница: 6 / 12

6
◆
Never pull the charger lead to
disconnect the charger from
the socket. Keep the charger
lead away from heat, oil and
sharp edges.
After use
◆
Unplug the charger before
cleaning the charger or
charging base.
◆
When not in use, the
appliance should be stored in
a dry place. Children should
not have access to stored
appliances.
Inspection and repairs
◆
Before use, check the
appliance for damaged or
defective parts. Check for
breakage of parts, damage to
switches and any other
conditions that may affect its
operation.
◆
Do not use the appliance if
any part is damaged or
defective.
◆
Have any damaged or
defective parts repaired or
replaced by an authorised
repair agent.
◆
Regularly check the charger
lead for damage. Replace the
charger if the lead is
damaged or defective.
◆
Never attempt to remove or
replace any parts other than
those specified in this manual.
Battery
◆
Never attempt to open the
battery for any reason.
◆
Do not expose the battery to
water.
◆
Do not incinerate the battery.
◆
When disposing of batteries,
follow the instructions given
in the section “Protecting the
Environment”.
Charger
◆
Do not expose the charger to
water.
◆
Do not open the charger.
ELECTRICAL SAFETY
Your charger has been designed
for a specific mains voltage.
Always check that the mains
voltage corresponds to the
voltage on the rating plate.
Your charger is double
insulated in accordance with
EN 60335; therefore no
earth wire is required.
Never attempt to replace
the charger unit with a
regular mains plug.
INSTALLATION
Fitting the charging base to the
wall (fig. B)
The charging base can be fitted
to the wall to provide a
convenient storage and charging
point for the appliance.
◆
Find a suitable indoor
location near a mains outlet.
◆
Position the charging base as
shown and mark the location
of the mounting holes (6) on
the wall.
◆
Drill a hole (ø 6 mm, approx.
35 mm deep) at each of the
marked locations.
◆
Insert the wall plugs (7)
provided into the holes.
◆
Fit the charging base to the
wall using the screws (8)
provided. Make sure to guide
the charger lead through the
slot (9). Excess lead can be
stored at the rear of the
charging base.
E N G L I S H
Dustbuster_UK_A5_A6.PM5 01-05-2001, 11:08 6