Black & Decker DUSTBUSTER DUO FV7201, Быстрый старт, Страница: 6 / 12

6
E N G L I S H
◆
Never pull the charger lead to
disconnect the charger from
the socket. Keep the charger
lead away from heat, oil and
sharp edges.
After use
◆
Unplug the charger before
cleaning the charger or the
charging base.
◆
When not in use, the
appliance should be stored in
a dry place. Children should
not have access to stored
appliances.
Inspection and repairs
◆
Before use, check the appliance
for damaged or defective parts.
Check for breakage of parts,
damage to switches and any
other conditions that may affect
its operation.
◆
Do not use the appliance if any
part is damaged or defective.
◆
Have any damaged or
defective parts repaired or
replaced by an authorised
repair agent.
◆
Regularly check the charger
lead for damage. Replace the
charger if the lead is damaged
or defective.
◆
Never attempt to remove or
replace any parts other than
those specified in this manual.
Battery
◆
Never attempt to open the
battery for any reason.
◆
Do not expose the battery to
water.
◆
Do not incinerate the battery.
◆
When disposing of batteries,
follow the instructions given
in the section “Protecting the
Environment”.
Charger
◆
Do not expose the charger to
water.
◆
Do not open the charger.
ELECTRICAL SAFETY
Your charger has been designed
for a specific mains voltage.
Always check that the mains
voltage corresponds to the
voltage on the rating plate.
Your charger is double
insulated in accordance with
EN 60335; therefore no
earth wire is required.
Never attempt to replace
the charger unit with a
regular mains plug.
INSTALLATION
Fitting the charging base to the
wall (fig. B)
The charging base and the
accessory storage base can be
fitted to the wall to provide a
convenient storage and charging
point for the appliance.
◆
Find a suitable indoor
location near a mains outlet.
◆
Place the charging base over
the accessory storage base as
shown, so that both sets of
holes line up.
◆
Position the assembled
charging / accessory storage
base as shown and mark the
location of the mounting
holes (13) on the wall.
◆
Drill a hole (ø 6 mm, approx.
35 mm deep) at each of the
marked locations.
◆
Insert the wall plugs provided
into the holes.
◆
Fit the assembled charging /
accessory storage base to the
wall using the screws
provided. Guide the charger
lead through any of the 3
slots (14).
Excess lead can be stored at
the rear of the charging base.