Black & Decker CHS6000, Оригинальное руководство пользователя

Страница: 6 / 96

6
ENGLISH
Vibration
The declared vibration emission values stated in the
technical data and the declaration of conformity have been
measured in accordance with a standard test method
provided by EN 60745 and may be used for comparing one
tool with another. The declared vibration emission value may
also be used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons
regularly using power tools in employment, an estimation of
vibration exposure should consider, the actual conditions of
use and the way the tool is used, including taking account of
all parts of the operating cycle such as the times when the
tool is switched off and when it is running idle in addition to
the trigger time.
Additional safety instructions for batteries and chargers
Batteries

Never attempt to open for any reason.

Do not expose the battery to water.

Do not expose the battery to heat.

Do not store in locations where the temperature may
exceed 40°C.

Charge only at ambient temperatures between 10°C
and 40°C.

Charge only using the charger provided with the
appliance/tool. Using the wrong charger could result in
an electric shock or overheating of the battery.

When disposing of batteries, follow the instructions
given in the section "Protecting the environment".

Do not damage/deform the battery pack either by
puncture or impact, as this may create a risk of injury
and fire.

Do not charge damaged batteries.

Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries, carefully wipe
the liquid off using a cloth. Avoid skin contact.

In case of skin or eye contact, follow the instructions
below.
Warning! The battery fluid may cause personal injury or
damage to property. In case of skin contact, immediately
rinse with water. If redness, pain or irritation occurs seek
medical attention. In case of eye contact, rinse immediately
with clean water and seek medical attention.
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.

Use your Black & Decker charger only to charge the
battery in the appliance/tool with which it was supplied.
Other batteries could burst, causing personal injury and
damage.

Never attempt to charge non-rechargeable batteries.

If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.

Do not expose the charger to water.

Do not open the charger.

Do not probe the charger.

The appliance/tool/battery must be placed in a well
ventilated area when charging.
Electrical safety
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Symbols on the charger

If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
The charging base is intended for indoor use only.
Your charger is double insulated; therefore no earth
wire is required.
Short circuit proof safety isolating transformer. The
mains supply is electrically separated from the
transformer output.
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charging base
must be disconnected from the mains supply and
taken to an authorised service centre for repair.
The charging base is intended for indoor use only.
130
o
C