Page 15
ENGLISH
Cleaning the Inlet Filter
Shut off the water supply and disconnect the inlet hose.
Pull out the filter with pliers, removing as shown. Clean the
filter and reinstall it.
Reconnect the inlet hose.
Turn on the water supply and make sure there is no
water leakage.
Drain Pump Filter:
The drain pump filter collects lint and small items so it does not pass through the
drain. It should be cleaned approximately once a month depending on frequency of
use.
If the washer does not empty or spin properly or if it makes an unusual noise during
draining, there may be an obstruction.
WARNING:
The drain pump filter should not be accessed while the unit is
operating or cycle has just been completed. There may be hot water
in the pump. Allow time for water to cool before access.
NOTE:
To avoid spills, place a tray underneath the compartment.
CLEANING AND CARE
1
1
To access the drain
pump filter, open
the compartment
on the bottom right
of the machine.
Remove debris.
Rinse off the pump
filter.
Reinsert the pump
filter and close the
compartment.
Turn the cap 90°
and pull out the
small hose.
Drain the water
from the small hose
into a container (not
included).
Remove the pump
filter by turning it
counterclockwise to
remove it.
2
Emergenc y
drain hose
3
4
5
6
