WARNING:
This appliance has a polarized plug (one blade on the plug is wider
than the other). To reduce the risk of electric shock, only use a polarized plug in a
polarized outlet. If the plug does not fit easily into the outlet, turn the plug over so
the right part of the plug fits in the outlet's other slot. If the plug still does not fit,
contact a qualified electrician. Do not modify the plug in any way.
USER SERVICING INSTRUCTIONS
1.
Remove the plug from the receptacle or other outlet device. Do not unplug by
pulling on the cord.
2.
Use a suitable tool such as a small flat screwdriver or travel scissors.
3.
When opening the fuse cover, slide open the fuse access cover on top of the
attachment plug towards the blades. (See Fig.1)
4.
Carefully remove the fuse by prying it out. (See Fig.2)
5.
A fire can result from using the wrong fuse rating. Only replace fuses with a 2.5
Amp, 125 Volt rating fuse. (replacement fuses are not included
）
6.
To close the fuse access cover, slide the fuse access cover on top of the attachment
plug. (see Fig.3)
Fig.1
Fig.2
Fig.3
7. Do not replace the attachment plug because it contains a safety device (fuse) that
should not be removed. Discard this product if the attachment plug is damaged
4
DIAGRAM
ASSEMBLING INSTRUCTIONS
1. Remove the Angle Adjustment Knob from the pre-assembled Front and Rear Guards
and Blade by turning the Angle Adjustment Knob counterclockwise.
2. Align the ends of the Left Leg/Support and the Rear Support (See Fig.1).
3. Press down on the left Leg/Support’s nut and push the Left Leg/Support into the
Rear Support until the nut snaps into place. The round hole in the Left Leg/Support
aligns with the round hole in the Rear Support.
4. Repeat Step 2 to connect the Right Leg/Support to the Rear Support. The hole in the
Left Leg/Support aligns with the hole in the Rear Support.
5. Align the sides of the pre-assembled Front and Rear Guards and Blade with the
corresponding holes on the Left and Right Legs. Make sure the Angle Adjustment
Knob fits over the outside of the Left and Right Legs and into the hole of the Front and
Rear Guards and Blade.
5. Turn the Angle Adjustment Knob clockwise to secure the Attachment (See Fig.2) but
do
not tighten.
OPERATING INSTRUCTIONS
1.
Place the fan on a level surface that is completely dry.
2.
Make sure the rotary switch is at the “0” (OFF) position.
3.
Plug the unit into a 120 V AC 60Hz outlet.
4.
Adjust the fan head vertically to your desired angle.
5.
To run the unit, turn the rotary switch to the “L” (Low), “M” (Medium) or “H”
(High) position.
6.
To turn the unit off, turn the rotary switch to the “0” (OFF) position.
Unplug the unit from the electrical outlet when it's not in use or is left unattended.
5