5
Grab the handle and lift upwards. Unwrap the
handle and hose from the main appliance. The hose
can extend up to approximately 4 feet (1.21m).
To place the handle and hose back onto the main
appliance, wrap the hose back underneath and
around the vac making sure that the hose fits
between the two “feet” of the appliance. Align the
handle with its cradle and click back into place.
The handle (2) can be removed from the hose
allowing the accessories to be connected directly to
the hose cuff (20) when desired.
To remove the handle:
• Unclip the handle (2) from the appliance.
• Rotate the locking ring (3) counterclockwise to
release the clips.
• Pull the hose away from the handle.
• Fit the accessory directly to the hose cuff (20).
To refit the handle:
• Remove the accessory from the hose.
• Push the hose into the handle (2). Rotate locking ring (3)
clockwise until it clicks into place.
ASSEMBLING FLOOR HEAD (FIGURE E)
(BDH1620FLFH, BDH2020FLFH ONLY)
This vacuum is equipped with a floor head for wider floor cleaning.
• Press and hold the accessory clip (11).
• Slide the floor head adapter (17) onto the handle (2).
• Connect the two floor head extensions (18), extention
connector (19), and the floor head (20) to the end for the
floor head adaptor.
NOTE:
Ensure that all parts of the floor head assembly are
securely connected.
CARPET / FLOORING SELECTOR SWITCH (FIGURE F)
The floor head’s agitator brush can be used for light
carpet cleaning and removing tough messes on
hard floors. It can be activated by depressing the
selector switch (21) located on the top of the floor
head accessory.
• To engage the agitator brush, depress the side of
the selector switch marked
.
• To disengage the brush, depress the side of the
selector switch marked
.
OPERATION
Before first use, the batteries must be charged for at least 4 hours.
• Connect the appliance to the charger for a minimum of 4 hours.
• Charge the batteries as described below.
CHARGING THE BATTERY (FIGURE G)
WARNING:
Charge only at ambient
temperatures between 50°F (10°C) and 104°F (40°C). The
charger supplied with this product is intended to be plugged in
such that it is correctly oriented in floor mount position.
To charge the appliance:
• Make sure the appliance is switched off. The battery will not be
charged with the on/off power switch (1) in the on position.
• Plug the charging base (15) into a standard 120 Volt 60
Hz electrical outlet.
• Lower the appliance onto the charging base. The LED (6)
in the base of the appliance will blink while charging.
• When charging is complete, the LED will turn off.
D
2
13
20
20
F
21
G
15
6
E
20
17
18
11
19