Black & Decker BDGL2223, Оригинальное руководство пользователя

Страница: 10 / 36

10
ENGLISH
(Original instructions)
Attaching the guard
1. Place the angle grinder on a work bench,
groove facing up.
2. Bring the flange of the guard (3) collar
over the groove (11) of the gear housing.
3. Turn the guard (4) counterclockwise by
150 degrees.
4. Make sure that the screws (20) are
tightened.
Removing the guard
1. Loosen the screws (20) on the guard
collar.
2. Pull up the guard (3).
Warning:
Do not operate the tool
when the safety guard is not in place.
Fitting and removing a grinding (Fig. C1,
C2, C3)
Warning:
Do not use damaged
grinding wheels.
1. Place the tool on a work bench, guard up.
2. Fit the inner flange (6) correctly onto the
spindle (7)
(Fig. C1).
3. Place the disc (8) on the flange (6)
(Fig.C2). When fitting a disc with a raised
center, make sure that the raised centre
(9) is facing the flange (6).
4. Screw the out flange (10) onto the
spindle (7) (Fig. C3)
- the ring on the flange (10) must fae
towoards the disc when fitting a grinding
disc (A)
- the ring on the flange (10) must face
away from the disc when fitting a cutting
disc (B)
5. Press the spindle lock (2) and rotate the
spindle (7) until it locks in position (Fig.
C2).
6. Tighten the flange (10) with the two-pin
spanner supplied.
7. Release the spindle lock.
8. To remove the disc, loosen the flange
(10) with the two-pin spanner.
Warning: Do not use a damaged
disc.
Mounting the side handle (Fig.D)
• For grinding, screw the side handle (4)
tightly into one of the holes (11) or (12) on
either side of the gear case.
Preparation Before Use
• Attach the safety guard and appropriate
abrasive or grinding wheels. Do not use
abrasive or grinding wheels that are
overly worn.
• Make sure that the inner and outer
flanges are attached correctly.
• Make sure that the abrasive or grinding
wheels are rotating in the direction of the
arrows on the accessories and tool.
Operation (Fig. F)
Instructions
Warning: Always observe the safety
instructions and applicable
regulations.
Warning: To minimize the danger of
serious personal injury, please
switch off the tool power and
disconnect all plugs before adjusting or
removing/installing any accessory. Before
reassembling the tool, press and release the
trigger switch to make sure the tool is
already switched off.
Warning:
• Make sure all materials to be grinded are
secured in position.
• Apply slight pressure to the tool. Do not
apply side pressure to the abrasive disc.
• Avoid overloading. If the tool becomes
hot, let it spin for a few minutes with no
load.
1. Be sure to hold the tool tightly with both
hands (one hand on housing, the other
on side handle). Start the tool and bring
the grinding wheel on the workpiece.