To start using the heater switch on the master switch at the back of the heater.
HEAT SETTINGS
To change the heat setting touch the
icon. Underneath the thermostat temperature on the main
display screen, dots will appear to signal what heat setting you are in. The light on the top of the unit
will also change colour depending on what heat setting you are in as per the below:
1 Dot
Blue
Fan Only Mode
2 Dots
Green
Heat Setting 1
3 Dots
Red
Heat Setting 2
The light can be turned off using the
icon on the remote.
OSCILLATION / SWING
To make the heater oscillate, touch the
icon and the heater will begin an oscillation cycle. The
angle of oscillation is approximately 75°.
ELECTRONIC THERMOSTAT
The temperature around the heater will always be displayed on the front screen. To increase the
temperature touch the
icon and to decrease the temperature touch the
icon. When the room
temperature reaches the preset temperature, the heating function will stop automatically. When the
room temperature is lower than preset temperature, the low or high heating will turn on automatically.
The thermostat range is between 16° and 37°.
TIMER
Hold on the
icon for 5 seconds to change the display to the timer mode. Press the
icon to
increase the timers hours and touch the
icon to decrease the timers hours. The timer will flash 3
times before confirming your set countdown time. The timer range is between 1 to 9 hours.
NOTES
•
The
heater’s
fan will continue to run approximately 30 seconds after the heater is turned off. This
is so the fan can cool down the ceramic heating element.
•
The display screen will automatically dim approximately 100 seconds after the icons have been
touched.
Operating your Heater
9
