Black & Decker BDCH188, Руководство пользователя

Страница: 7 / 12

ENGLISH (Original instructions)
7
u
Open the chuck (4) by turning the front part with one
hand while holding the rear part with the other.
u
Insert the bit shaft into the chuck and firmly tighten the
chuck.
This tool is supplied with a double-ended screwdriver bit in
the bit holder (6).
u
To remove the screwdriver bit from the bit holder, lift
the bit from the recess.
u
To store the screwdriver bit, firmly push it into the
holder.
Use
Warning! Let the tool work at its own pace. Do not
overload.
Warning! Before drilling into walls, floors or ceilings,
check for the location of wiring and pipes.
Charging the battery (fig. A)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that
were easily done before. The battery may become warm
while charging; this is normal and does not indicate a
problem.
Warning! Do not charge the battery at ambient tem-
peratures below 10 °C or above 40 °C. Recommended
charging temperature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above
40 °C.
The battery should be left in the charger and the
charger will begin to charge automatically when the
cell temperature warms up or cools down.
u
To charge the battery (7), insert it into the charger (8).
The battery will only fit into the charger in one way. Do
not force. Be sure that the battery is fully seated in the
charger.
u
Plug in the charger and switch on at the mains.
The charging indicator (9) will blink.
The charge is complete when the charging indicator (9)
switches to continuously on. The charger and the battery
can be left connected indefinitely. The LED will switch on
as the charger occasionally tops up the battery charge.
u
Charge discharged batteries within 1 week. Battery
life will be greatly diminished if stored in a discharged
state.
Leaving the battery in the charger
The charger and battery pack can be left connected with
the LED glowing indefinitely. The charger will keep the
battery pack fresh and fully charged.
Selecting the direction of rotation (fig. C)
For drilling and for tightening screws, use forward
(clockwise) rotation. For loosening screws or removing a
jammed drill bit, use reverse (counterclockwise) rotation.
u
To select forward rotation, push the forward/reverse
slider (2) to the left.
u
To select reverse rotation, push the forward/reverse
slider to the right.
u
To lock the tool, set the forward/reverse slider into the
centre position.
Selecting the operating mode or torque (fig. D)
This tool is fitted with a collar to select the operating mode
and to set the torque for tightening screws. Large screws
and hard workpiece materials require a higher torque set-
ting than small screws and soft workpiece materials. The
collar has a wide range of settings to suit your application.
u
For drilling in wood, metal and plastics, set the collar
(3) to the drilling position by aligning the symbol with
the marking.
u
For screwdriving, set the collar to the desired setting.
If you do not yet know the appropriate setting, proceed
as follows:
u
Set the collar (3) to the lowest torque setting.
u
Tighten the first screw.
u
If the clutch ratchets before the desired result is
achieved, increase the collar setting and continue
tightening the screw. Repeat until you reach the
correct setting. Use this setting for the remaining
screws.