Black & Decker BDCD12BC, Инструкция по эксплуатации

Страница: 10 / 40

English
8
Fig. D
3
5
Fig. C
5
6
Proper Hand Position (Fig. D)
WARNING:
To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle
3 and one hand on the battery pack. Hold tool
firmly with both hands to control the twisting action of
the drill.
Performing an Application (Fig. A)
WARNING: To reduce the risk of personal
injury, ALWAYS
ensure workpiece is anchored or
clamped firmly.
WARNING:
Always wait until the motor has come to
a complete standstill before changing the direction
of rotation.
Prior to performing work:
Install the appropriate bit or accessory into the chuck.
Refer to
"installing a Bit or Accessory into a Keyless Two
sleeve Chuck" .
WARNING:
• Do not use this tool to mix or pump easily
combustible or explosive fluids (benzine,
alcohol, etc.).
Variable Speed Trigger and Forward/
Reverse Control Button (Fig. A)
The tool is turned on and off by pulling and releasing
the variable speed trigger 1 . The farther the trigger is
depressed, the higher the speed of the tool. Your tool is
equipped with a brake. The chuck will stop as soon as the
trigger switch is fully released.
A forward/reverse control button
2 determines the
rotational direction of the tool and also serves as a
lock-off button.
• To select forward rotation, release the trigger and
depress the forward/reverse control button on the right
side of the tool.
• To select reverse, depress the forward/reverse control
button on the left side of the tool.
nOTE: The center position of the control button locks the
tool in the off position. When changing the position of the
control button, be sure the trigger is released.
nOTE: Continuous use in variable speed range is not
recommended. It may damage the switch and should
be avoided.
nOTE: The first time the tool is run after changing the
direction of rotation, you may hear a click on start up. This is
normal and does not indicate a problem.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. A, C)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
5 into the tool handle, align the
battery pack with the rails inside the tool’s handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
6
and firmly pull the battery pack out of the tool
handle. To charge, insert into the charger as described in the
charger section of this manual.
After removing the battery, squeeze the tool trigger for
three seconds to dissipate the slight electric charge that
may still be in the tool. The worklight may come on for a
brief moment.