![background image](http://html.mh-extra.com/html/black-and-decker/90538065/90538065_instruction-manual_32026005.webp)
• Remove the fan cover from the bottom of the power head by pressing the spring loaded
release button (located on the back of the power head) and pulling the cover off (
figure 7
).
• Attach the vacuum tube assembly to the power head
(figure 8)
by locating the assembly as
indicated by arrow, then pivot about this point until the locking/release catch is fully engaged.
REMOVING BLOW TUBE, VAC TUBE OR COLLECTION BAG (FIGURE 7 & 9)
• To remove the blow tube, vac tube or shoulder collection bag, depress the release button on
the power head and pull straight off (
figure 7 & 9
).
OPERATION
USE AS A BLOWER:
ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER MASK IF THE OPERATION IS
DUSTY. USE OF RUBBER GLOVES AND SUBSTANTIAL FOOTWEAR IS
RECOMMENDED WHEN WORKING OUTDOORS. FOR HOUSEHOLD USE ONLY.
WARNING: CUT HAZARD.
When turning the tool off for tube installation or any other
reason, wait 10 seconds for the fan to stop rotating before disassembly.
• Do not use in vacuum mode without the vacuum tubes and collection bag in place.
• Always switch off and remove the plug from the electrical supply when:
• Changing from blower to vacuum.
• The power supply cord has become damaged or entangled.
• You leave blower/vac unattended.
• Clearing a blockage.
• Checking, adjusting, cleaning or working on blower/vac.
• Use blower/vac only in daylight or good artificial light.
ON/OFF SWITCH (FIGURE 10)
MODEL LH5000
Your blower vac is fitted with a variable speed switch located on the top of the power head
below the handle.
• To turn the tool ON, rotate the knob clockwise. The further the knob is rotated, the higher the
air speed.
• To turn tool OFF, rotate the knob counterclockwise to the off position (0).
MODEL LH4500
Your blower vac is fitted with a two speed switch located on the top of the power head below
the handle.
• To use in low speed, rotate the knob clockwise to Position I. To use in high speed, rotate the
knob clockwise to Position II.
• To turn tool OFF, rotate the knob counterclockwise to the off position (0).
9
8
7
10
5