To clean inner water screen, first remove the garden hose connector. Turn counter-clockwise to
remove the garden hose connector from the machine inlet. Then remove the filter screen from the
inlet. Backflush screen to clean. Replace screen and garden hose connector immediately to
prevent any foreign matter from entering the pump.
14
1) When finished using the pressure washer, you must first flush clean water through the
detergent injection system.
2) Turn the machine OFF and squeeze the trigger to release the trapped pressure inside of the
machine.
3) Disconnect the garden hose and the high pressure hose from the front of the unit.
4) Turn ON the machine and allow it to run for 5 seconds. (This will clear out most of the water
trapped in the pump)
5) Store the machine and accessories in a dry, climate controlled environment.
Do not store the
machine or accessories in a place where the temperature could drop below 40°F. FREEZE
DAMAGE IS NOT COVERED BY THE WARRANTY.
Connections
NOTICE:
If the screen is not kept clean, the flow of water to the pressure washer will be
restricted and the pump may be damaged.
Connections on Pressure Washer hoses, gun and spray wand should be cleaned regularly and
lubricated with non-water soluble grease to prevent leakage and damage to the o-rings.
Nozzles
The nozzles should be lubricated with non-water soluble grease or light oil regularly.
Clogging of the nozzle causes the pump pressure to build up too high and cleaning is immediately
required.
1) Clear blockage in nozzle by forcing stiff wire through center hole.
2) Backflush the nozzle with water. Restart the pressure washer and depress the trigger on the
spray gun. If the pressure is still too high, repeat steps 1-2.
Lubrication
The pressure washer is designed with a permanent lubrication system. Conventional oil check and
oil changes are not necessary.
NOTE: In case of oil leakage, contact our customer service department.
Water Screen
NOTICE:
Do not damage the screen while removing or cleaning. Any foreign particles
entering the pump may damage the pump.
NOTICE:
Do not overtighten garden hose connector to machine inlet. Damage and leaking
will occur. Any damage will not be covered under warranty.
END OF USE AND WINTER STORAGE INSTRUCTIONS
CARE AND MAINTENANCE
