BKI WDCG Series, Руководство по эксплуатации

Страница: 14 / 39

12
Pedestal Model
Leveling
Deli cases must be installed level to insure proper operation and alignment to adjoining equipment. Use a
carpenter’s level and begin leveling from the highest point of the store floor.
1. Level the case using the leg levelers at the corners of the pedestals (see Figure 3).
2. Raise the low end of the case to level it, do not lower the high end.
3. Check for level side-to-side and front-to-back.
Figure 3. Pedestal Model - Leveling and Cover Attachment
Pedestal Wrap Installation
1. Remove the Rear Trim from the back of each Pedestal by removing the (4) retaining screws on
each Rear Trim.
2. Spread the side panels of the Pedestal Wraps apart far enough to fit around Pedestal and slide
the Pedestal Wrap around the Pedestal from the front as shown in Figure 3. Make certain the
Pedestal Wrap fits flush to the floor.
NOTES: There are left and right hand Pedestal Wraps. The taller side panel on each Pedestal
Wrap is oriented to the end of deli case.
The short return flange on the front of each Pedestal Wrap side Panel will insert into the large cut
out in the front of the Pedestal. The back flange of each Pedestal Wrap side Panel will wrap
around the back of the Pedestal.