BK Radio DRH-01-100, Руководство оператора

Страница: 12 / 16

10 DRH-01-100 User’s Guide
optimizing transmit Power
The DRH-01-100 is factory tuned to achieve a minimum of 100 Watts RF
output across the full band of the repeater (136 - 174 MHz). RF power
can be adjusted to a lower output on your operating frequency within
the parameters of the power amplifier. The minimum power output of the
DRH-01-100 is approximately 50 Watts.
To access the DRH-01-100 transmit power
adjustment click the “Global” folder in the left
panel then select “Adjust Power”.
adjusting the Power
Connect the Transmit Antenna Connector to an RF power meter capable
of reading a minimum of 250 Watts.
Enter the programmed transmit
frequency in the Tx Freq box.
Click the “Start Tx” button. 1.
Record the Power DAC Setting. 2.
Use the slider bar for course 3.
adjustment and the arrows for
fine tuning to achieve the desired
power output.
Click the “Stop Tx” button to set 4.
the power.
notE: Changing the power settings at one frequency may cause
degraded performance at other frequencies. If the operating
frequency is changed the RF power must be readjusted for that
frequency.
To meet the minimum 100 watts specification the power DAC
should be reset to its original value prior to changing the operating
frequency.