BK Precision 4060B Series, Руководство по программированию

Страница: 9 / 28

Common Command Introduction 9
Query Format <channel>:OUTPut?
Query Response <channel>:OUTP <load>
Example Turn on channel one.
C1:OUTP ON
Read channel one output state.
C1:OUTP?
Return:
C1:OUTP ON, LOAD, HZ, PLRT, NOR
Set the load to 50.
C1:OUTP LOAD, 50
Set the load to HZ.
C1:OUTP LOAD, HZ
Set the polarity normal.
C1:OUTP PLRT, NOR
Set the polarity inverted.
C1:OUTP PLRT, INVT
2.13 Basic Wave Command
Description Sets or gets basic wave parameters.
Command Syntax <channel>:BaSic_WaVe <parameter>
<channel>={C1, C2}
<parameter>:={a parameter from the table below}
2.13.1 Paramters
Note: if the command doesn’t set basic wave type, WVPT parameter will be set to current
wave type.
where:
<type>={SINE, SQUARE, RAMP, PULSE, NOISE, ARB ,DC}
<frequency>={Default unit is "Hz". Value depends on the model.}
<amplitude>={Default unit is "V". Value depends on the model.}
<offset>={Default unit is "V". Value depends on the model.}
<duty>={0% to 100%. Value depends on frequency.}
<symmetry> ={0% to 100%}
<phase>={0 to 360 if you set 400,it will set 40(400-360)}
< standard deviation >={Default unit is "V". Value depends on the model.}
<mean>={Default unit is "V". Value depends on the model.}
<width>={Max_width < (Max_duty * 0.01) * period and Min_width >
(Min_duty * 0.01) * period.}
<rise>={Value depends on the model.}
<fall>={Value depends on the model.}
<delay>={Unit is S. Maximal is Pulse period, minimum value is 0.}
<bandwidth switch >={ON,OFF}
<bandwidth value>={value between 20MHz and 120MHz}